Sorry, I should have explained my setup better. I have the second set of M80s on the Amp Assign. Electrically, I thought that this would control each pair individually (4 ohms) rather than in parallel (2 ohms)please correct me if I am wrong.
On the question of the different Ohm readings for top and bottom binding posts, are the readings I am getting normal? If so how are the speakers wired internally? If the reading is not normal what should the correct readings be? And finally is there a way to rewire the speaker to get a higher resistance?
I have an old Harman Kardon PA2400 in storage I think it was rated @ ~200 wpc if I recall correctly. Would this be sufficient to power the M80s ? I use to run 4 Cerwin Vega VS150s on this amp and never had a problem.
Thanks
