When using the Trigger, the EP500 does not always wake up properly. The LED on the back switches from red to green however the sub output level is severely reduced. In other words it is working but at say 20% volume. The only way to recover is to cycle the power on the EP500.
This is the same issue i was having... i discussed it with Brent, i made the decision to just let the amps idle as they were not "turning on" even though the LED was indicatig the circuitry had switched from off to on. i.e. red to green.... i verified the trigger being used was working by using it on one of the amps, the trigger in question works just fine. I was getting 0 out put though, not reduced output. As though the amp had not switched on at all....
