Yes I did carefully mount my components on my new crossover board and I securely mounted the new crossovers to the inside floor of the M60.

Components (per speaker):

1. There are 3 inductors 1 each for tweeters, mids, woofers - I did not measure them, they are unmarked for value, and I just reused them.

2. Resistors - Mids two 20W15R & two 20W5R - Tweeters 7W5R & 7W10R - Woofers none

3. Caps - Tweeters 3.3uf & 4.7uf - Mids 3.3uf - Woofers none

I would like to add that doing this is not for the faint of heart. I chose to totally rebuild the crossovers because the factory pc boards are very small in size. All the factory components are mounted close together and are secured by globs of hot glue. There is little room to work with the factory boards.

I had to totally disassemble the speakers to do this project.

The VP150 and QS8's sound wonderful now too.