Previous Thread
Next Thread
Print Thread
Rate Thread
Page 1 of 3 1 2 3
Another Router question
#183762 11/15/07 04:17 PM
Joined: Jul 2004
Posts: 4,444
Likes: 16
M
connoisseur
OP Offline
connoisseur
M
Joined: Jul 2004
Posts: 4,444
Likes: 16
I now have need for a wireless router. I managed to run a screw through a cable to the furthest LAN jack location where my son has his X-box set up. I plan to still use my hard wired LAN (I have two network printers), but want a couple more locations in the house that do not have LAN jacks. I understand that Linksys makes multi-port wireless routers that might fill this need. When I look at their product guide, I’m a bit confused to which one I should buy.

I will also be using an 8 port switch with this router for the hard wired LAN outlets in use, if that matters.

In addition to the router, I need a couple of those gadgets that the device uses to talk to the router (showing my IT ignorance with these high tech terms). I don’t know if they make this, but I’d like to plug all my A/V electronics in the HT room that have Ethernet into. My receiver, HD player, BR player and video processor will all need to plug in to this thing (if it exists). The receiver has network streaming and the rest just use Ethernet for firmware updates. I can always plug them in whenever I need to update firmware, but the receiver will need constant communication with the router.

The router will be located in my office on the second level of the house. The X-box is on the fifth level about 60 feet away from the router. My A/V equipment is on the first level about 40 feet away from the router.

So in summery, I’m looking for 1) a good wireless router for a large home with some hard wire ports for my hard wire LAN. 2) a couple single port widgets that talk to the router 3) a multi port widget that talks to the router.

I supose I should also mention that the location where I will need to mount the router is in a stud space in my office wall. It can't be much larger than the four port router I have already.

Re: Another Router question
michael_d #183775 11/15/07 04:58 PM
Joined: May 2003
Posts: 18,044
shareholder in the making
Offline
shareholder in the making
Joined: May 2003
Posts: 18,044
OK, so to break it down, you need a wireless router with a built in switch (WRT54G would be my recommendation, although there's about 40000 different versions of it). You need something to translate from wireless to wired? Am I getting that right? I'm sure such a beastie exists, but I'm not sure where one would find one or if they actually work. I know you can do it with a second wireless router, but it takes some clever set up.

Although as I think about it, all you need are single 802.11e->ethernet converters, which there are plenty of.

The WRT54G is identical to your current router, as far as I remember, other than having the two antennae. You can get larger antennae for it, depending on which model you have.


I am the Doctor, and THIS... is my SPOON!
Re: Another Router question
Ken.C #183781 11/15/07 05:10 PM
Joined: Dec 2003
Posts: 10,420
J
shareholder in the making
Offline
shareholder in the making
J
Joined: Dec 2003
Posts: 10,420
The output from the standard WRT54G series I found to be too weak for my house with the router in the basement, even with the high gain antennas on both PC and router. The router is located middle of the house(in tha basement) and the computers I have on the first and second floors at all corners of the house. I had to go to a router that uses MIMO(Multiple In Multiple Out) signals, I no longer have weak signals. I just bought the new 'N' router, WRT300N it does all the standards. I run mine in BG mode to enable the Wii to connect wireless as well, it just wouldn't hook up in G mode for some reason.


Jason
M80 v2
VP160 v3
QS8 v2
PB13 Ultra
Denon 3808
Samsung 85" Q70
Re: Another Router question
Ken.C #183782 11/15/07 05:15 PM
Joined: Jul 2004
Posts: 4,444
Likes: 16
M
connoisseur
OP Offline
connoisseur
M
Joined: Jul 2004
Posts: 4,444
Likes: 16
What’s an Ethernet converter?

The router you mention, does that one have good range? In Linksys still a good make? I’ve been hearing they aren’t so hot anymore and Cisco screwed them up.

What is this A, G, B rating that I see listed with some routers?

Re: Another Router question
michael_d #183784 11/15/07 05:20 PM
Joined: May 2003
Posts: 18,044
shareholder in the making
Offline
shareholder in the making
Joined: May 2003
Posts: 18,044
Ethernet converter is my own made up word; I'm just talking about a device that converts ethernet into 802.11 wireless ethernet. This would be an example, albeit a crummy one. They seem to be fairly hard to find.

A, B, G, and draft-N are different types (and speeds) of wireless. You need to know what you have before you go out and buy a wireless router. A is in the 5GHz range and tops out at 54MB/sec. B is the generic, 2.4GHz range, tops out at 11MB/sec. B is the common denominator; just about everything that's wireless supports this. However, if it's used on a network, it slows down everything else, so you probably don't want B equipment on your network. G is 2.4GHz, tops out a 54MB/sec. 2nd most common; A is fairly rare. draft-N is 2.4GHz or 5GHz, topping out at something like 200MB/sec. Fairly rare, not a certified standard yet, but increasing in popularity. Theoretically long range.

Here's a review of current draft-N routers.

EDIT: teach me not to use preview...



Last edited by kcarlile; 11/15/07 05:29 PM.

I am the Doctor, and THIS... is my SPOON!
Re: Another Router question
Ken.C #183786 11/15/07 05:29 PM
Joined: Dec 2003
Posts: 10,420
J
shareholder in the making
Offline
shareholder in the making
J
Joined: Dec 2003
Posts: 10,420
I can attest to the long range even in my mixed mode and not N.


Jason
M80 v2
VP160 v3
QS8 v2
PB13 Ultra
Denon 3808
Samsung 85" Q70
Re: Another Router question
jakewash #183787 11/15/07 05:43 PM
Joined: Jan 2007
Posts: 10,490
Likes: 116
M
shareholder in the making
Offline
shareholder in the making
M
Joined: Jan 2007
Posts: 10,490
Likes: 116
Mike,

One of the things that you might want to do is contact the manufacturers of the devices that will be wired and ask them for their wireless routed recommendation. I know that if your wired device communicates using the same standard as the router it should be fine but it doesn't hurt to ask what they recommend. They may for example know which router make and model is most robust making your selection that much easier.


House of the Rising Sone
Out in the mid or far field
Dedicated mid-woofers are over-rated
Re: Another Router question
Mojo #183799 11/15/07 06:04 PM
Joined: Jun 2003
Posts: 8,488
T
axiomite
Offline
axiomite
T
Joined: Jun 2003
Posts: 8,488
I use a quarter-inch rounding over bit unless I need an ogee.

You guys make everything so complicated sometimes.

Mike, you're going to have to break down and draw a picture. I'll bet Ken can solve your problem. But he might need a site visit.


bibere usque ad hilaritatem
Re: Another Router question
tomtuttle #183801 11/15/07 06:09 PM
Joined: May 2003
Posts: 18,044
shareholder in the making
Offline
shareholder in the making
Joined: May 2003
Posts: 18,044
I'm just not sure what you mean about the media room, Mike. I'm assuming you don't have ethernet wired to that room, so you need connectivity through wireless. Given that, I'm not sure how you're handling it right now--I know you're using all of those devices!


I am the Doctor, and THIS... is my SPOON!
Re: Another Router question
tomtuttle #183804 11/15/07 06:11 PM
Joined: Sep 2004
Posts: 11,458
shareholder in the making
Offline
shareholder in the making
Joined: Sep 2004
Posts: 11,458
Tom:
You and I think alike. I was going to recommend this model as being very reliable:



::::::: No disrespect to Axiom, but my favorite woofer is my yellow lab :::::::
Page 1 of 3 1 2 3

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,940
Posts442,457
Members15,616
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 386 guests, and 4 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4