Previous Thread
Next Thread
Print Thread
Rate Thread
Page 9 of 31 1 2 7 8 9 10 11 30 31
Re: EP800s Under Repair Again
terzaghi #285906 01/08/10 03:29 AM
Joined: Mar 2008
Posts: 1,378
SRoode Offline OP
connoisseur
OP Offline
connoisseur
Joined: Mar 2008
Posts: 1,378
It has to be at least ep1300...


LFR1100 Actives,QS10HPx2,QS8x2,EP800,M3x4,M3x2 (Wood),M5HPx2 (Wood),AxiomAir,ADA1500-8,ADA1500-7
Re: EP800s Under Repair Again
SRoode #285918 01/08/10 05:15 AM
Joined: Jul 2006
Posts: 12,077
Likes: 7
C
CV Offline
Founder, Axiom Upgrade Club
shareholder in the making
Offline
Founder, Axiom Upgrade Club
shareholder in the making
C
Joined: Jul 2006
Posts: 12,077
Likes: 7
 Originally Posted By: SRoode
You won't need an A/B comparison...

Usually I would say something like "the new amp breathes new life into the EP800", but this change is extreme. The change will be noticed without an A/B comparison.

You will be very afraid of it! \:\)


What kind of graph would this change be seen on?

It's a serious question. I have no doubt there's a difference, but I'm wondering where it shows up on paper.

Re: EP800s Under Repair Again
CV #285927 01/08/10 07:24 AM
Joined: Feb 2009
Posts: 3,466
connoisseur
Offline
connoisseur
Joined: Feb 2009
Posts: 3,466
Because the amp was seeing an 2 Ohm load, this would cause current to flow very easily. While that does increase the power output of an amp, it can increase it beyond spec. An amp pushed beyond its design limits will have a higher THD, this comes from the output stage not being able to handle that much current. Distortion can also come from clipping if the transformer can't provide enough power, and sags under the demand. Even without clipping an over taxed power supply will cause dynamic range compression, and lower output levels.


Pioneer PDP-5020FD, Marantz SR6011
Axiom M5HP, VP160HP, QS8
Sony PS4, surround backs
-Chris
Re: EP800s Under Repair Again
ClubNeon #285938 01/08/10 01:28 PM
Joined: Apr 2007
Posts: 4,877
connoisseur
Offline
connoisseur
Joined: Apr 2007
Posts: 4,877
There you have it. Mr neon explains all.


-David
Re: EP800s Under Repair Again
Ian #285994 01/08/10 09:35 PM
Joined: Dec 2008
Posts: 1,361
connoisseur
Offline
connoisseur
Joined: Dec 2008
Posts: 1,361
 Originally Posted By: Ian
CV,

Anyone with one of the original amps in their EP800 that wants to make the replacement to the new amp is no problem. Changing it over is a bit more involved then just switching the amp but it is not too bad. You need to remove both woofers in the process because the wiring is different but we will send the new amp with the new wires already attached.


Wow. Nice (and appropriate) move. You will never make it at Samsung!


Panny 3000 PJ, 118" Carada, Denon 3300, PS3, Axiom QS8, PSB 5T, B&W sub, levitating speaker wire
Re: EP800s Under Repair Again
Zimm #285995 01/08/10 09:53 PM
Joined: Mar 2008
Posts: 1,378
SRoode Offline OP
connoisseur
OP Offline
connoisseur
Joined: Mar 2008
Posts: 1,378
I can tell you that it certainly "feels" different. There is noticeably much more rumble from the new amp. I have the new amp at only 50% gain and the old at 90% gain. The new amped speaker drivers have the same throw as the old with these settings, but the rumble and air pressure sensations in the room is much greater.


LFR1100 Actives,QS10HPx2,QS8x2,EP800,M3x4,M3x2 (Wood),M5HPx2 (Wood),AxiomAir,ADA1500-8,ADA1500-7
Re: EP800s Under Repair Again
SRoode #285996 01/08/10 10:00 PM
Joined: Dec 2008
Posts: 1,361
connoisseur
Offline
connoisseur
Joined: Dec 2008
Posts: 1,361
Good. I'll give you $100 American dollars for that old junkie ep800 you don't need anymore. You just cover shipping...Deal?


Panny 3000 PJ, 118" Carada, Denon 3300, PS3, Axiom QS8, PSB 5T, B&W sub, levitating speaker wire
Re: EP800s Under Repair Again
SRoode #286083 01/09/10 03:26 PM
Joined: Feb 2008
Posts: 1,005
O
onn Offline
connoisseur
Offline
connoisseur
O
Joined: Feb 2008
Posts: 1,005
 Originally Posted By: SRoode
I can tell you that it certainly "feels" different. There is noticeably much more rumble from the new amp. I have the new amp at only 50% gain and the old at 90% gain. The new amped speaker drivers have the same throw as the old with these settings, but the rumble and air pressure sensations in the room is much greater.


An update
I woke up this morning at 0300 and proceeded to switch my amp out. Did a quick recalibrations and put a test disk in the OPPO (UB-571 Depth charge scene). The way I have my crossovers set up is 40 for all 4 of my M80's and 80 for the VP150. Steve is right in saying that the rumbing effect is much greater with the new amp as compared to the old. The gain knob on the old is set about 55% and on the new is 65%. which is opposite to Steve probably due to room layout and sub placement. I have errands to do the rest of the day so tomorrow will give me time to further test this new amp out.

Re: EP800s Under Repair Again
onn #286245 01/10/10 04:34 PM
Joined: Feb 2008
Posts: 1,005
O
onn Offline
connoisseur
Offline
connoisseur
O
Joined: Feb 2008
Posts: 1,005
I did a test with the LOTR The Return of The King DVD and yes Steve is correct. You do get more of the deep bass shaking than with the old amp. It will be scary when the other one shows up. I did have new rattles in the house that I didn't have before that I will have to try to eliminate. \:D
All an all a great upgrade IMO

Re: EP800s Under Repair Again
onn #286246 01/10/10 04:43 PM
Joined: Aug 2007
Posts: 3,488
Likes: 9
connoisseur
Offline
connoisseur
Joined: Aug 2007
Posts: 3,488
Likes: 9
 Originally Posted By: onn
It will be scary when the other one shows up.

Ask Axiom to attach a bell to the box. It won't scare you if you hear it coming... ;\)


See Mojo's signature
Page 9 of 31 1 2 7 8 9 10 11 30 31

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,939
Posts442,452
Members15,615
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 221 guests, and 0 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4