Previous Thread
Next Thread
Print Thread
Rate Thread
Funny Amp question...
#50323 06/23/04 05:31 AM
Joined: Dec 2003
Posts: 289
M
MykeW Offline OP
local
OP Offline
local
M
Joined: Dec 2003
Posts: 289
A friend and I were talking audio today and a question arose as to wether one could link ("bridge") a couple of amps or channels in either a stereo amp or multichannel amp togethor to effectively double the output to a speaker. ( perhaps similar to what is done when you switch an amp/reciever to bridge mode )

ie: say one has a 50 watt stereo amp. Could one connect the same input to both channels and then both outputs to the same speaker to get the equivalent of 100 watts output to a single speaker?

Would there be any problems with doing this, other than a bit of complicated wiring?

(Note: I'm not asking about using the separate channels to Bi-amp, but wether one could combine the channels)

Thanks for the help! Cheers, Jag

Re: Funny Amp question...
#50324 06/23/04 08:31 AM
Joined: May 2002
Posts: 10,654
shareholder in the making
Offline
shareholder in the making
Joined: May 2002
Posts: 10,654
Mike, it's possible even with amps that don't have built-in provision for bridging, but it would take a lot more than just wiring. What is involved in bridging two amp sections is sending the voltage from the positive terminal of both amps(instead of positive and negative of one amp)into the terminals of the single speaker. Now if this added those two voltages together, then the power would be theoretically quadrupled(not just doubled)because pursuant to one form of Ohm's law power is equal to voltage squared divided by resistance(P=V(squared)/R)so twice the voltage equals four times the power(losses make it more like three times in practice).

The problem is that with the majority of amps, which don't have bridging provisions, the voltages of the two amp sections are in phase with each other and would in effect run head on into each other in the speaker and cancel out, not add together. One of the amp outputs would have to be inverted in phase 180 degrees with respect to the other amp so that in effect one would be pulling in the same direction as the other was pushing and their voltages would then add. There are bridge converters, adaptors,inverters, etc. around or plans to build them.


-----------------------------------

Enjoy the music, not the equipment.


Re: Funny Amp question...
#50325 06/23/04 03:19 PM
Joined: Dec 2003
Posts: 289
M
MykeW Offline OP
local
OP Offline
local
M
Joined: Dec 2003
Posts: 289
Once again JohnK very informative and helpful.

Cheers, Mike


Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,940
Posts442,457
Members15,616
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 585 guests, and 1 robot.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4