Axiom Home Page Forums General Discussion Technical Questions Wall mounting the M1ti

Hello,
I just purchased the Epic Mini system and I am in the middle of setting up the system. I need to wall mount the M1s to the front wall. I purchased a set of Omnimount AB2 which can hold up to 8lbs each. I would like to do a wall to back of speaker type of mount but there are no pre-drilled holes in the speaker. My question is can I drill into the back of these speakers? If so, how deep can I go into the cabinet? If I was to drill a hole I think I would do it under the port and above the binding posts. However, I am a little relunctant because this is my very first home theater system and I don't want to damage these speakers before I even have a chance to listen to them...

Thanks-

This is a very good location to drill holes for your mounting bracket on the M1s. I would suggest using a guide on the drill bit to keep the drill from penetrating more than 3/4".