Axiom Home Page
Posted By: Samson When to EQ, When to Let It Be? - 10/26/05 03:19 PM
I've had my setup in place, and have been enjoying it, for months now (M22, QS4, VP100, SVS PB-12 ISD). I've calibrated the system with AVIA and the RS SPL meter.

For the past week I've been playing with the RoomEQ Wizard to learn more about my setup's room response (specifically subwoofer response), and I was somewhat shocked with the results. Despite the fact aesthetics was a primary factor in placement of the speakers, and zero flexibility in adjusting the location, my room response for the 160Hz and lower frequencies looks pretty darn good.

I'll post the graph later, but I was wondering if there was a rule of thumb for determining acceptable dB variance for frequencies under let's say 200Hz. The practical question is whether my current room response (which only varies about +/- 3 dB from the target of 80dB)would benefit from EQ'ing via a parametric equalizer like the BFD.

There is a larger dip in response (-10dB) at 125Hz, which I was able to smooth a bit with my receiver's (Denon 2805) manual EQ - I juiced it by 4dB).

Lastly, I'm interested in knowing the general advantages and costs to EQ'ing a system, and the frequency above which it is not considered reasonable to target with EQ tweaking.

I've looked at the AVS and audioholics sites for this info, but couldn't dig up exactly what I was looking for.

Thanks.
Posted By: Samson Re: When to EQ, When to Let It Be? - 10/27/05 11:12 AM
Here's the room response (I apologize for the size, I can figure out how to resize the jpeg!), as measured by RoomEQ Wizard and a RS SPL meter. Is this response deserving of some EQ futzing? Would I hear a difference in smooting out +/- 5 dB peaks and dips?


Posted By: MarkSJohnson Re: When to EQ, When to Let It Be? - 10/27/05 12:16 PM
Personally, I think that's a better plot than many are able to achieve. It's much, much better than mine, that's for sure.

I wouldn't mess with it!
Posted By: pmbuko Re: When to EQ, When to Let It Be? - 10/27/05 04:57 PM
I agree that your response is pretty good. I resized the image and adjusted the scale a bit so it was easier to see the whole thing:



If I had to pick one thing, though, I'd trim the peak at 38Hz since it's about 5 dB above your curve's average.
Posted By: WhatFurrer Re: When to EQ, When to Let It Be? - 10/27/05 06:15 PM
Excuse my asking this but is the "Room EQ Wizard" a piece of software or a web app?

In either case, where can it be found...?

Interested in seeing how my room is affecting my sound...

Thanks,

WhatFurrer
Posted By: Ajax Re: When to EQ, When to Let It Be? - 10/27/05 08:41 PM
Here ya go, Steve. It's free.

Welcome to the Room EQ Wizard Web Page

And there is a long thread on AVS.

Room EQ Wizard
© Axiom Message Boards