Any know of any short speaker stand for the Axiom M80? I need about 4 more inches off the floor. It sounds much better at this height. I currently place it on a cabinet stand that does not look good.
If I can not find a good look one, I was thinking about designing myself. Does any one have the bottom rubber boot mount hole locations and sizes. Meaning what is the screw thread size. I am currently not at my home so I can not measure it. I am currently in China so I am thinking I can design and get it made here.
What you guys think?
phone book
phone book
Make sure it's from the same city/year otherwise dispersion curve will be affected.
Guys,
I have some concepts that I have already done. I need more dimensions to finalized it. Like the screw size that is on the bottom of the speaker. It would be nice to be able to get the 3D data for the speaker as well. It would allow better integrated design. If you guys have any information, please share. I already took a look at the link above and was not able to get much information from it.
Johny
Try emailing Axiom. I'm sure they have all the info you need.
But we are much more entertaining
If you don't get anwers you want from axiom let me know and I will make some measurements.
Basically it comes down to we are all too lazy or too busy on here to measure them.
Nah, Jason. Some of us either just don't care or don't want to help.
But I still enjoy the theatre of it all.
Anybody try CALLING Axiom on this deal?
I am sure the sizes were posted awhile back, maybe a check with the Good/Working search engine in the water cooler might be fruitful.
Unfortunately, I've only got measly 60s so I'm useless.
Some would argue the same end-result even if I bought 80s.
It's not you Mark, it's your room.
:::: runs away crying...arms flailing wildly ::::
Unfortunately, I've only got measly 60s so I'm uselessinadequate.
There, fixed.
Oh, he already ran away crying. Drat!
I'm really just around the corner, pouting, if you guys want to apologize... (sniff-sniff)
Aaaw, we were just funnin' ya. C'mon back out and play.
Mind, none of that funky blue zappy stuff. OK?
I would measure it if I can. I am currently in China and don't have the speaker with me. As mentioned before, I wanted to get it made while I am here. I could measure it when I return and have it made next time I am back in China.
I did try to contact Axiom. No response to my request. So I am stuck right now until I return to the US or some provide me some information. I have tried to search around for this information and have no luck. I will try again.
Johny
Check back later today/tonight and I will see if I can find some time to do a measure for you.
Jason,
Were you able to get those dimensions? I would really appreciate if you can. Thank you.
Johny
I see some spare time tonight( been very busy putting the backyard back together after some recontruction to remake our patio). I shall try to rememebr tonight. I even wrote it down on my to do list for today.
The screw size is 1/4"-20
Guys,
I want to post some images. But I don't know how.
Johny
Ft spacing is 6.25" and rear is 4.75" on center, but I would go with a slotted hole to allow for minor variances.
To post an image, your picture must be online somewhere, like
photobucket or any other web service. Then you can show it in your post by putting [img] and [/img] around the link to the image.