As part of the ongoing research and development at Axiom, we build a prototype sample woofer to test its characteristcs. Because we are able to do this in-house, changes in design and subsequent testing can be conducted right at Axiom's facilities.

Alan Lofft holds the large two-inch woofer voice coil on its assembly, the starting piece for building a sample woofer.

Debbie Swinton prepares a mounting jig for the voice coil, to which the aluminum cone is attached later in the process.

Debbie removes the installed voice coil assembly from the mounting jig.

Here Debbie has attached the voice coil to the flexible spider.

A layer of glue is applied to the base of the magnet assembly.

The ferrite magnet is glued to the magnet assembly. Later on, the ferrite core will be magnetized in Axiom's magnetizer.

Here she glues a retainer ring to the ferrite magnet. The retainer ring and magnet assembly will be attached to the large aluminum woofer basket.

In this picture, Debbie screws the cast aluminum basket to the speaker magnet assembly.

The completed aluminum basket with its attached woofer magnet structure.

Debbie uses a jig to center the voice coil and spider assembly in the center of the magnet structure, and glues it into place.

A bead of glue is applied to the voice coil spider assembly, ready to receive the aluminum woofer cone.

Finally, Debbie takes the aluminum cone and its composite rubber surround to glue it to the basket and voice-coil assembly.

Debbie shows the completed 12-inch woofer driver, ready for testing.