FMS CC
Step 1 | Step 2 | Step 3 | Step 4 | Step 5 | Step 6 | Step 7 | Step 8 | Step 9
Print | Contact | Close Window
Step 1:
Attach the spikes OR rubber feet to the base, using the supplied screws. Puncture the rubber membrane by pushing the screw through the rubber foot. Your choice of feet does NOT affect sound quality.
top
Step 2:
Turn the threaded end of the pillar, clockwise into the triangular metal base. Tighten these parts together - do not over tighten.
top
Step 3:
Place the collar on top of the pillar. Temporarily tighten one of the set screws. Do not over-tighten this screw.
FMS-CC - Diagram 1
top
Step 4:
Run your speaker wire inside the pillar, and out the notch in the collar. Leave enough wire to connect to the speaker later on.
FMS-CC - Diagram 2
top
Step 5:
Pull down the support bars and tighten the supplied screws to secure the platform. Using the three screws supplied, attach the platform to the top of the metal collar. The upright support tab should be facing up.
FMS-CC - Diagram 3
FMS-CC - Diagram 4
top
Step 6:
Unscrew the bolt already installed in the back of your center channel. Position your speaker onto the platform.
FMS-CC - Diagram 5
top

Step 7:Align the speaker and upright support tab holes. Screw in and tighten the bolt to secure the speaker onto the stand. Do not over-tighten this screw.
FMS-CC - Diagram 6
Step 8:
Connect your speaker wire to your speaker.

top
Step 9:
Loosen the collar set screw in Step 3. Position your speaker so it faces forward. Finally, securely tighten all the collar set screws.
FMS-CC - Diagram 7
 
top

For any additional information or service, contact:
Axiom Audio Head Office
2885 Highway 60
Dwight, ON Canada
P0A 1H0

Toll Free (North America): 1-866-244-8796
Worldwide: 1-705-635-3090
Email: info@axiomaudio.com

www.axiomaudio.com