have you ran audessey with the supplied mic?
When you copied the eq curve was everything at 0 db or was there already changes made to the curve?
If audessey had ran correctly then when you first copied the curve you should see all of the changes that audessey implemented for each frequency listed.
on page 43 of the manual it says that if you changed the settings of a speaker which was set to "none" then you can not select audyssey EQ. not sure what they mean by this, but maybe if you had surrounds or SW set to "none" during the auto eq, and then later added it in by manually changing SW to "yes" or connecting surrounds then you have to re-run audessey.
David, I did indeed use the supplied microphone and ran the Audyssey setup this morning.
