Hey guys,

Just a quick question. I am planning using the M22s for studio monitors, and was wondering if you guys could confirm my thoughts.

I am going to be using a monitor switching device, have the M22s on A and the EP400 (or EP350) on B. I want to be able to run the M22s full range, and also add the sub for mixing. Basically I want to be able to switch between the M22s only, full range, and then add the sub to the M22s. Would I be able to let the M22s roll off naturally, and not cross them over to the sub with a hard cross over? The sub will be filtered at 80hz, but the M22s will be full range. Would using 60hz on the sub provide a better mix? I am worried about the 60-80hz range having a hump since the M22s are responsive down to 60hz and if the Sub is filtered at 80hz, both the sub and the M22s will be playing the 60-80hz range.

I hope I make sense, I have been researching this for weeks, and just wondering what you guys think.


Producer | Composer
www.robbhutzal.com