Get Free, Friendly, Expert Advice
Call 1-866-244-8796 or email

Designed and Manufactured in Canada Since 1980


AxiomAudio Blog

Axiom’s New Computer Speakers

Blind Listening Tests

Sneak Peek into Axiom’s Current Research and Development

Wall'O'Fame
Solarrdadd's 7.1 Apartment HT!
A promise is A promise... Axiom's second home
Who's Online
0 registered (), 35 Guests and 7 Spiders online.
Key: Admin, Global Mod, Mod
Financing
Forum Stats
13360 Members
11 Forums
23078 Topics
408058 Posts

Max Online: 378 @ 02/24/13 04:33 PM
Top Posters
Ken.C 17843
pmbuko 16319
SirQuack 13356
CV 11388
MarkSJohnson 11061
Meanwhile On Facebook

(y) That countdown timer is finally off their site! Great to see high-quality s...

⚠ Only 5 days left in our Computer Speaker Presale! http://www.axiomaudio.com/c...

(y) Love this review a customer sent us recently: "Bottom line, these speakers...

❔ The new M1 High Powered Computer Speaker uses Axiom's latest full one-inch twe...

Page 2 of 2 < 1 2
Topic Options
Rate This Topic
#1599 - 03/04/02 08:42 PM Re: material construction
Anonymous
Unregistered


Good point, I am sure there is an answer



Top
#1600 - 03/05/02 06:40 AM Re: material construction
Ian Offline
President
aficionado

Registered: 03/13/01
Posts: 822
There are actually many factors that come into play when you are looking at the ability of the woofer to maintain control during bass reproduction at high volume. The mass of the cone is only one factor and in fact aluminum is not, in most instances, heavier than other cone materials, but it does have a better stiffness to mass ratio. Another very important factor to consider when trying to achieve clean reproduction of low frequencies at high volume is the motor control of the voice coil. Regardless of the cone material if the combination of the cone travel, voice coil length, and BL in the top plate gap are not sufficient to maintain control of the woofer the bass performance at higher volume levels will get very ugly. Thus in the design of the woofer itself we need to consider all of the factors surrounding bass distortion at high volume. This is an area where we have spent much time researching.

Ian Colquhoun
President & Chief Engineer
_________________________
Ian Colquhoun
President & Chief Engineer

Top
Page 2 of 2 < 1 2



Moderator:  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Home  |  Corporate Info  |  Products  |  Message Board  |  FAQs  |  Warranty  |  Site Map  |  Privacy Statement   |  Contact Us

©2014 Colquhoun Audio Laboratories Limited
All Rights Reserved.