Previous Thread
Next Thread
Print Thread
Rate Thread
Page 5 of 28 1 2 3 4 5 6 7 27 28
Re: Emotiva MPS-1 shutting down? Amp gurus help
SirQuack #162414 03/27/07 12:17 AM
Joined: May 2003
Posts: 18,044
shareholder in the making
Offline
shareholder in the making
Joined: May 2003
Posts: 18,044
Yeah, Dennis switched to Parasound Halos. Which are significantly more expensive than Emotivas. Significantly...

OTOH, he was also driving 5 M80s and 2 QS8s to 115 dB, so it's a little bit different.


I am the Doctor, and THIS... is my SPOON!
Re: Emotiva MPS-1 shutting down? Amp gurus help
Ken.C #162415 03/27/07 02:18 AM
Joined: May 2004
Posts: 1,201
connoisseur
Offline
connoisseur
Joined: May 2004
Posts: 1,201
Dennis was able to shut down the Parasounds in that big ole room of his. He was approaching nearly the same spl's as Randy, but with a Rocket setup(1000's x 2, 850's x 3, qs8's x 2).

We just figured that he played them to their capacity, and then joked that he should get rid of the A21's in favor of some JC1's...

I still would like to know what is going on with Randy's M80's and MPS-1...


*Michael*
AV123 Refugee - X-LS Encore, X-Voce, X-Omnis, Elt-Dpa's
Denon AVR-591
Magnavox NB500MGX BDP

Re: Emotiva MPS-1 shutting down? Amp gurus help
Ken.C #162416 03/27/07 02:26 AM
Joined: Aug 2004
Posts: 6,379
Likes: 7
axiomite
Offline
axiomite
Joined: Aug 2004
Posts: 6,379
Likes: 7
From what I remember, the Outlaw amp simply couldn't get rid of heat fast enough when running at sustained high volumes with mostly 4 ohm speakers. In his case there was an "overtemp" light that came on (and everything was really hot ) so it was pretty clear what the problem was.

Does the Emotiva have enough idiot lights to indicate whether this is a temperature or current limit shutdown ? I would re-read the thread but I'm running at about 6 bps on dial-up right now (if I meant 6 Kbps I would have *said* 6 Kbps ) so I can't bear to go read the thread again, sorry.


M60ti, VP180, QS8, M2ti, EP500, PC-Plus 20-39
M5HP, M40ti, Sierra-1
LFR1100 active, ADA1500-4 and -8
Re: Emotiva MPS-1 shutting down? Amp gurus help
SirQuack #162417 03/27/07 03:18 AM
Joined: Jan 2007
Posts: 10,490
Likes: 116
M
shareholder in the making
Offline
shareholder in the making
M
Joined: Jan 2007
Posts: 10,490
Likes: 116
Quote:

In regards to Audioholics findings of 256 watts into 4 ohms, they assured me that they are in fact 300watts into 4 ohms as stated. They are not sure of the exact test that was used to get these figures (mainly what equipment/ load banks, etc.), but they assured me and will back their specs up every day of the week that their amps do produce the power that they are rated. This is something Emotiva takes very seriously and they do not play games with the figures.





Randy, every manufacturer has the best intentions. You may want to ask Emotiva to show you the test specification (complete with test set-up) and signed test results to verify the above claim. If they take it that seriously, they should have documented proof so that they and their customers can rest easy.

Re: Emotiva MPS-1 shutting down? Amp gurus help
bridgman #162418 03/27/07 03:22 AM
Joined: Dec 2005
Posts: 3,301
connoisseur
Offline
connoisseur
Joined: Dec 2005
Posts: 3,301
I've run my Aragon 2005 at some pretty extreme levels powering 5 speakers and never had a problem, I didn't check my SPL levels but my wife did call from across the street and tell me to turn it down.
I'm betting there is a problem somewhere other than just driving the amp to hard.


A computer once beat me at chess, but it was no match for me at kick boxing.
Re: Emotiva MPS-1 shutting down? Amp gurus help
bridgman #162419 03/27/07 03:27 AM
Joined: Jan 2004
Posts: 13,840
Likes: 13
shareholder in the making
OP Offline
shareholder in the making
Joined: Jan 2004
Posts: 13,840
Likes: 13
Each amp has the following:

Blue Led - Power module is installed, online, and ready.

Amber Led - Power module is installed and powered on but is in a standby situation waiting for audio signal or external trigger.

Red Led - This indicates a fault condition. A fault condition is one or more of the following:
.excessive operating temprature
.excessive current (short circuit)
.DC on the outputs

When my amps shutdown I get a red led for that channel that shuts down.


M80s VP180 4xM22ow 4xM3ic EP600 2xEP350
AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85


Re: Emotiva MPS-1 shutting down? Amp gurus help
SirQuack #162420 03/27/07 04:20 AM
Joined: May 2004
Posts: 1,201
connoisseur
Offline
connoisseur
Joined: May 2004
Posts: 1,201
What is the temperature of the amp when it shuts down? Cool, warm, or hot?


*Michael*
AV123 Refugee - X-LS Encore, X-Voce, X-Omnis, Elt-Dpa's
Denon AVR-591
Magnavox NB500MGX BDP

Re: Emotiva MPS-1 shutting down? Amp gurus help
richeydog #162421 03/27/07 01:37 PM
Joined: Jan 2004
Posts: 13,840
Likes: 13
shareholder in the making
OP Offline
shareholder in the making
Joined: Jan 2004
Posts: 13,840
Likes: 13
It is still pretty cool, I had not been running it very long.


M80s VP180 4xM22ow 4xM3ic EP600 2xEP350
AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85


Re: Emotiva MPS-1 shutting down? Amp gurus help
SirQuack #162422 03/27/07 04:05 PM
Joined: Aug 2004
Posts: 6,379
Likes: 7
axiomite
Offline
axiomite
Joined: Aug 2004
Posts: 6,379
Likes: 7
OK, that's good news.


M60ti, VP180, QS8, M2ti, EP500, PC-Plus 20-39
M5HP, M40ti, Sierra-1
LFR1100 active, ADA1500-4 and -8
Re: Emotiva MPS-1 shutting down? Amp gurus help
bridgman #162423 03/27/07 08:02 PM
Joined: Jan 2004
Posts: 13,840
Likes: 13
shareholder in the making
OP Offline
shareholder in the making
Joined: Jan 2004
Posts: 13,840
Likes: 13
They told me they will make this right for me, and I totally believe they will. If not they said, they will take the unit back. They are sending me some new amps, and Lonnie is personally runnning a QA on them before they leave. He wants to explore his thought on the Bias adjustment on the amps I have as possibly being set slighly off.

The amps have two Bias adjustments, a manual one that is set during production, and an automatic one that alters itself based on the situation.

He also said that the owner of the company is running 4 ohm speakers as well that are far more expensive than Axioms, and has no problems. He does not think it is the m80s. Only time will tell.


M80s VP180 4xM22ow 4xM3ic EP600 2xEP350
AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85


Page 5 of 28 1 2 3 4 5 6 7 27 28

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,940
Posts442,457
Members15,616
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 386 guests, and 4 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4