Previous Thread
Next Thread
Print Thread
Rate Thread
Page 7 of 8 1 2 3 4 5 6 7 8
Re: Crackling speakers
NeoE46 #241518 01/20/09 12:39 AM
Joined: Feb 2007
Posts: 602
H
aficionado
Offline
aficionado
H
Joined: Feb 2007
Posts: 602
I wasn't really listening to it "super" carefully, but I didn't notice any sizzling sound. I was watching it via Samsung 1400, bitstreamed audio to Denon 3808 (and M80/QS8/EP500)


--
Denon 4520, EPIC80/500/VP180 Speakers
Re: Crackling speakers
Hansang #241554 01/20/09 04:07 AM
Joined: Jul 2006
Posts: 12,077
Likes: 7
C
CV Offline
Founder, Axiom Upgrade Club
shareholder in the making
Offline
Founder, Axiom Upgrade Club
shareholder in the making
C
Joined: Jul 2006
Posts: 12,077
Likes: 7
I don't remember what I was watching when it has happened, but I have had what would probably be the same crackling/whatever sound. It happens so rarely that I never thought it was worth investigating, as it doesn't just seem to be a certain volume causing it.

Re: Crackling speakers
CV #241634 01/20/09 06:36 PM
Joined: Jan 2009
Posts: 6
N
regular
Offline
regular
N
Joined: Jan 2009
Posts: 6
It is not related to volume. I can hear it at both low and high volumes leading me to believe it is just part of the soundtrack. Don't remember if I stated this or not, but it sounded like it was coming from the tweeters. Either the speakers do a good job at revealing what is there or my setup is doing a bad job of representing the sound the engineers hoped to reproduce.

Re: Crackling speakers
NeoE46 #241724 01/21/09 02:20 AM
Joined: Jan 2004
Posts: 13,840
Likes: 13
shareholder in the making
Offline
shareholder in the making
Joined: Jan 2004
Posts: 13,840
Likes: 13
Neo, you have not described your setup, I assume your using surrounds? If not, is it possible the surround channel is being routed to your 80's? Are you using Dolby or DTS modes? etc... speakers set to small?


M80s VP180 4xM22ow 4xM3ic EP600 2xEP350
AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85


Re: Crackling speakers
SirQuack #241950 01/22/09 05:02 AM
Joined: Sep 2008
Posts: 612
aficionado
OP Offline
aficionado
Joined: Sep 2008
Posts: 612
Thanks everyone for the feedback, sorry for the delinquency in my replies, serious time constraints nowadays, wish you all well.

Thanks for the observation, NeoE46 that helps, now I realize there is little point in testing the left speaker as on that particular passage I observed the same across approximately four listens, mostly left speaker with a moderate amount of center involvement.

Thanks Jason for the concept, when/if I get time to do formal testing I will plug my notebook in and “get real,” i.e., engage in formal observation. It’s nice to know how that would be accomplished.

Thanks Jay, I share the same conviction/plan re: the 663, steps would be: 1) obtain subwoofer, 2) hire electrician as/if necessary, 3) upgrade processor once I have some clue re: what features I desire beyond stability/HD audio.

I’m reluctant to admit, Jay given that I have such limited experience with HT and the ability to EQ systems by ear in general seems so deficient; however, the “wind/applause” issue I suspect is related to the lack of thunderousness in the LFs. To be more specific, the problem seemed to be that when the crossover was set to 80 HZ, the surrounds were way too shrill/prominent in the sense that they did not mesh with the M80s/VP150, which always merge together to an amazing degree regardless of crossover setting. At 40 hz crossover setting the qs8s seem to provide ambient sound without being obtrusive.

In the absence of a sub most of this seems silly conjecture, I’m trying to reproduce HT sound with just the M80s doing double duty, i.e., Mains/LFE, so I am waiting to “fix” my set up until the sub arrives; however, since this thread is still active, I submit the following observations for your review:

1) I noticed the bogus crackling sound again that I sincerely doubt is due to sloppy audio engineering in the last (?) episode of the Matrix, at the end before the swarm/baby face appears, the defect did not appear until then which made me suspect that newer videos (Iron Man, Hulk, Dark Knight) might emphasize heavy LFEs more (?) and make the problem more prominent.

2) My reference scene remains LOTR first episode where they are destroying the forest, that’s when I first became convinced there was just no way that the engineers were that lame, to use a distinctly electrical popping sound to represent trees falling.

3) On every occasion of hearing the sonic defect I have experimented briefly and was unable to clearly reproduce the crackling sound at low volumes, at least in any way that was obvious to me as the same sonic representation at a lower level of amplification (i.e., no distinct crackling sounds).

4) The 663 actually shut down during loud experimentation with one of the defective sounding passages (Iron Man?), yes my hand was on the middle of the remote but nowhere near the power off button (which is at the top of the Harmony One as well as the 663 remote).

5) Problem does not seem to exist when I do NOT send the LFEs to the M80s.

For the above reasons I:
1) Continue to suspect faulty LFE processing or reproduction, especially given that cheesy HF crackling sounds should not emerge when LFEs are engaged unless there is a processing/reproduction defect.

2) Find it difficult to plausibly attribute the crackling sounds to faulty recording or intrinsically faulty speaker design.

3) Am waiting for sub before any attempt to correct since if I do not send LFEs to M80s I most likely will no longer have a problem.

Well perhaps this has been less than a waste of time since others have experienced transient issues with same and perhaps we might learn something, on the other hand it remains a ghost in the machine until someone can explain at least the Dark Knight passage, is it a defect in the recording, processing, or reproduction?

Best all,
SK




"If you try to turn toward it, you go against it."
Re: Crackling speakers
SirQuack #242509 01/24/09 10:50 PM
Joined: Jan 2009
Posts: 6
N
regular
Offline
regular
N
Joined: Jan 2009
Posts: 6
 Originally Posted By: sirquack
Neo, you have not described your setup, I assume your using surrounds? If not, is it possible the surround channel is being routed to your 80's? Are you using Dolby or DTS modes? etc... speakers set to small?


I have the following eq.

(L/R)Axiom M60, (C)Axiom VP150, (S/R)Axiom QS8
(Media)PS3, (AVR) Temporary Denon 1609...waiting on Emotiva UMC-1

Speakers set to Large. Crossover @ 60hz. Dolby Digital with PLex for the rear. Setup with Audyssey(sp?)

Re: Crackling speakers
NeoE46 #242516 01/24/09 11:23 PM
Joined: Jan 2004
Posts: 13,840
Likes: 13
shareholder in the making
Offline
shareholder in the making
Joined: Jan 2004
Posts: 13,840
Likes: 13
I would recommend you set all your speakers to small, especially your center and Qs8's as your sending frequencies below what those speakers can handle effectively below the crossover. Also, you want to use 80hz, not 60hz. This may or may not be your problem.


M80s VP180 4xM22ow 4xM3ic EP600 2xEP350
AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85


Re: Crackling speakers
SirQuack #242538 01/25/09 12:40 AM
Joined: Dec 2008
Posts: 505
B
aficionado
Offline
aficionado
B
Joined: Dec 2008
Posts: 505
 Originally Posted By: sirquack
I would recommend you set all your speakers to small, especially your center and Qs8's as your sending frequencies below what those speakers can handle effectively below the crossover. Also, you want to use 80hz, not 60hz. This may or may not be your problem.


From what I was reading I thought I would see this answer come up.

Re: Crackling speakers
BoB/335 #242547 01/25/09 01:45 AM
Joined: Dec 2003
Posts: 10,420
J
shareholder in the making
Offline
shareholder in the making
J
Joined: Dec 2003
Posts: 10,420
It`s the industry standard, you make adjustments according to individual tastes from there.


Jason
M80 v2
VP160 v3
QS8 v2
PB13 Ultra
Denon 3808
Samsung 85" Q70
Re: Crackling speakers
SirQuack #242570 01/25/09 04:11 AM
Joined: Jan 2009
Posts: 6
N
regular
Offline
regular
N
Joined: Jan 2009
Posts: 6
Clarification: Only the L/R are set to large or full range. There is not much difference in S/Q between the two settings. No difference in soundstage.

As I said, I was concerned at first, but I don't think this is a problem with the setup. I think I am hearing something in the material as this is the only time I have heard the noise. Plenty of other soundtracks with huge bass and punch. Only this soundtrack at this particular time.

Page 7 of 8 1 2 3 4 5 6 7 8

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,940
Posts442,457
Members15,616
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 386 guests, and 4 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4