Previous Thread
Next Thread
Print Thread
Rate Thread
Page 1 of 2 1 2
ROTEL RECEIVER not RATED FOR 4 Ohm?,
#283053 12/19/09 09:13 AM
Joined: Jan 2009
Posts: 150
C
veteran
OP Offline
veteran
C
Joined: Jan 2009
Posts: 150
I read a review today indicating that the new Rotel 1550 AVR is rated at 75 watts per channel into 8 ohms. The review goes on to say that the receiver is not rated for 4 ohm use. Does this mean that its OK to use this receiver with 4 ohm speakers but the receiver wasn't tested for them and thus is still unrated? I believe that this receiver is capable of driving M80's. What is your opnion? See http://www.rotel.com/content/reviews/15%20series/rsx1550-equip_rotel_cm.pdf Thanks...Lee

Re: ROTEL RECEIVER not RATED FOR 4 Ohm?,
Captain4105 #283057 12/19/09 02:55 PM
Joined: Feb 2005
Posts: 5,210
axiomite
Offline
axiomite
Joined: Feb 2005
Posts: 5,210
Lee, everything I've read suggest that yes you can drive the 4 ohm 80s with the 1550 without any problems and I personally believe there should not be any issues but you may want to ask the question over on the Club Rotel forums...

Club Rotel

This looks like a very nice AVR, I like it!


Rick
Our Room

smile
Re: ROTEL RECEIVER not RATED FOR 4 Ohm?,
RickF #283058 12/19/09 03:05 PM
Joined: Jun 2003
Posts: 6,833
W
Wid Offline
axiomite
Offline
axiomite
W
Joined: Jun 2003
Posts: 6,833

No where in the manual of the RB1080 does it say it's rated at 4 ohm but it sure does a nice job with the 80s. I'm sure the 1550 will work fine.


Rick


"A fear of weapons is a sign of retarded sexual and emotional maturity." Sigmund Freud

Re: ROTEL RECEIVER not RATED FOR 4 Ohm?,
Captain4105 #283122 12/20/09 02:32 AM
Joined: May 2002
Posts: 10,654
shareholder in the making
Offline
shareholder in the making
Joined: May 2002
Posts: 10,654
Lee, the reason that the 1550 and so many other receivers that can handle 4 ohm rated speakers with no problem in real-world home use can't claim an "official" 4 ohm rating is the severity of the tests they would have to pass. The FTC(Federal Trade Commission)has regulations for amplifier power ratings which have to be followed for any units sold in the U.S(and which, as a practical matter, are the same as those sold in Canada), and the UL(Underwriters Laboratory)tests for overheating. In brief, for an official 4 ohm rating the unit would have to be operated at the full rated power for at least five continuous minutes into a 4 ohm load. Most units aren't designed for such an ordeal without overheating and having their protective circuits shut them down.

Nevertheless, for actual home use the 1550 and many other receivers are serving their owners well driving speakers, including the M80s, which are rated at 4 ohms. Incidentally, you might also note that the M80s are 8 ohm speakers over the majority of their frequency range.


-----------------------------------

Enjoy the music, not the equipment.


Re: ROTEL RECEIVER not RATED FOR 4 Ohm?,
JohnK #283129 12/20/09 03:18 AM
Joined: Jun 2003
Posts: 6,833
W
Wid Offline
axiomite
Offline
axiomite
W
Joined: Jun 2003
Posts: 6,833

That's not what I see when looking at the M80 impedance graph John. While a majority of the graph shows the M80s above their 4 ohm rating it certainly does not show them to be "8 ohm speakers over the majority of their frequency range".


Rick


"A fear of weapons is a sign of retarded sexual and emotional maturity." Sigmund Freud

Re: ROTEL RECEIVER not RATED FOR 4 Ohm?,
Wid #283177 12/20/09 05:35 PM
Joined: Jan 2004
Posts: 13,840
Likes: 13
shareholder in the making
Offline
shareholder in the making
Joined: Jan 2004
Posts: 13,840
Likes: 13
Here is the graph for reference. Looks like it is 8ohm or above from around 700hz - 2K, and 5K to 20K Hz.




M80s VP180 4xM22ow 4xM3ic EP600 2xEP350
AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85


Re: ROTEL RECEIVER not RATED FOR 4 Ohm?,
SirQuack #283179 12/20/09 05:47 PM
Joined: Jun 2003
Posts: 6,833
W
Wid Offline
axiomite
Offline
axiomite
W
Joined: Jun 2003
Posts: 6,833

Yes it is from 700hz - 2K but it is not up to 20K, it shows it from 5k to around 12k. Put a straight edge on the graph and it will show it. The point being it does not show the 80s as being "8 ohm speakers over the majority of their frequency range".


Rick


"A fear of weapons is a sign of retarded sexual and emotional maturity." Sigmund Freud

Re: ROTEL RECEIVER not RATED FOR 4 Ohm?,
Wid #283181 12/20/09 06:04 PM
Joined: Jan 2004
Posts: 13,840
Likes: 13
shareholder in the making
Offline
shareholder in the making
Joined: Jan 2004
Posts: 13,840
Likes: 13
Which is why I showed the graph, to confirm your statement. Didn't take the time to use a straight edge, to lazy.


M80s VP180 4xM22ow 4xM3ic EP600 2xEP350
AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85


Re: ROTEL RECEIVER not RATED FOR 4 Ohm?,
SirQuack #283183 12/20/09 06:07 PM
Joined: Jun 2003
Posts: 6,833
W
Wid Offline
axiomite
Offline
axiomite
W
Joined: Jun 2003
Posts: 6,833

Got ya.


Rick


"A fear of weapons is a sign of retarded sexual and emotional maturity." Sigmund Freud

Re: ROTEL RECEIVER not RATED FOR 4 Ohm?,
Wid #283226 12/21/09 02:36 AM
Joined: May 2002
Posts: 10,654
shareholder in the making
Offline
shareholder in the making
Joined: May 2002
Posts: 10,654
Speakers are rated on an average of their impedances, not the minimum. The NRC graph does in fact show that the M80s are 8 ohm speakers over the majority of their frequency range.


-----------------------------------

Enjoy the music, not the equipment.


Page 1 of 2 1 2

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,940
Posts442,457
Members15,616
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 145 guests, and 4 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4