Axiom Home Page Forums General Discussion Technical Questions No sound from M80 tweeters or mids

Just unpacked and hooked up one of my M80's for the first time and was surprised at how muddy the sound was, until I realized there was no sound coming from the tweeters or mid drivers. I unpacked and connected the second M80 and it was fine (sounds great actually!).

I remember seeing others with a similar problem but can't recall if there was a solution. Hopefully someone can chime in, TIA.

Check to make sure the connecting bars are in place and making contact between the binding posts. I’ve had them come a little loose and lost the one set of drivers when the wires were connected to the other post.

If that doesn’t work there could be a loose wire at a crossover. Not sure if you should check that w/o contacting Axiom first. Others might be able to say.

Nut, the connecting strips between the low and high frequency terminals, as Dean mentioned, are most likely loose.

Hi,

If the bridging bars are snugged and secured and you still can't get the mids and tweeters going; remove them and feed the signal (connecting your speaker wires) alternatively only to the top pair and to the lower pair of binding posts. The top pair should give you audio from the mids and the tweeters only; the lower pair from the woofers only.

If the top pair still does not provide any audio and the botom one allows you to get audio from the woofers then dial Axiom's toll free number 1.866.244.8796 for immediate assistance.

Thanks grunt & John, I will double check again to make sure the connecting bars/strips are secure. If they are then I will try JC's suggestion and see what happens. Fingers crossed!

As per JC's instructions the woofers work with the bottom pair but the mids & tweets still do not work with the top pair

I will try calling Axiom tomorrow.

Funny, I thought this was another Ashok thread.

Hey, don't jinx my speakers! Either he's got the worst luck in the world or something is causing them to fail...

Yep..that was me.
Mine did not work even after replacing both the tweeters. I called and got a replacement M80.

Makes me wonder if quality control needs to wake up at Axiom
Do they run each and every speaker on the test bed? Mine went bad after a year or so though.

The test bed would have needed a flux capacitor...