Previous Thread
Next Thread
Print Thread
Rate Thread
Page 3 of 6 1 2 3 4 5 6
Re: How would I build an axiom home theatre for 1kish?
jakewash #308286 05/27/10 07:16 PM
Joined: Sep 2009
Posts: 212
S
local
Offline
local
S
Joined: Sep 2009
Posts: 212
 Originally Posted By: jakewash
 Originally Posted By: snazzed

The M22s will pull 200W per chanel according to specs.


Just to be clear speakers do not PULL power out of an amp, speakers offer resistance (4, 8, 16 ohms etc) to power flow. The amp feeds them power and in this case the M22 can handle 200W per speaker without failing; as long as it is clean power.


Picky, picky, picky!

The M22 speaker will laugh in the face of power sources less than 200W!

Better? :p

snazzed


M22, VP150, QS8 <--all v2
Sub: Outlaw LFM1-Plus
Denon AVR1910, Sony X900-65"
Re: How would I build an axiom home theatre for 1kish?
snazzed #308287 05/27/10 07:22 PM
Joined: Feb 2009
Posts: 3,466
connoisseur
Offline
connoisseur
Joined: Feb 2009
Posts: 3,466
Still, a 350 Watt amp driving M22s to uncomfortable listening levels, but not near it's limit will cause less damage than a 75 Watt amp driven hard into clipping. The later will more than likely ruin the tweeters.


Pioneer PDP-5020FD, Marantz SR6011
Axiom M5HP, VP160HP, QS8
Sony PS4, surround backs
-Chris
Re: How would I build an axiom home theatre for 1kish?
ClubNeon #308290 05/27/10 07:46 PM
Joined: May 2010
Posts: 28
B
Bakajon Offline OP
hobbyist
OP Offline
hobbyist
B
Joined: May 2010
Posts: 28

Ah I see, so ideally having an amp with a higher head-room would keep the sound cleaner. nifty.

I am learning a lot from you guys tyvm.

Next question. :P I have a set of bluesky media 2.1's...

If I wanted to could I integrate the satalights into an axiom set up to save cash initially? Here are my current left and right channels.

Was thinking maybe with a splitter they could make a good center channel.

You can see a pic of my current two sats in the top right. I think they could be driven by the amplifier.

http://abluesky.com/products/mediadesk-2-1-mkii/

Re: How would I build an axiom home theatre for 1kish?
Bakajon #308291 05/27/10 07:51 PM
Joined: May 2010
Posts: 28
B
Bakajon Offline OP
hobbyist
OP Offline
hobbyist
B
Joined: May 2010
Posts: 28
So right now I am convinced that I need m22's, any "decent" subwoofer. has anyone tried the vp125 axiom made? the low end 375 dollar one?

And those rear surrounds look dreamy, so for sure I am buying axiom m22's and the rear surrounds, and very likely a low end woofer from them so I don't shake the house.

Oh this may sound like a silly question but are Axion speakers considered to be full range? I know my old ones are, I bought them for 500 dollars, they seem kind of wimpy compared to the axioms but I am curious in terms of range how they stack up? I am sure they will be better cut just curious.

By the way thank you all so much for all this help. Your awesome. :P

Last edited by Bakajon; 05/27/10 07:52 PM.
Re: How would I build an axiom home theatre for 1kish?
Bakajon #308296 05/27/10 08:17 PM
Joined: May 2010
Posts: 28
B
Bakajon Offline OP
hobbyist
OP Offline
hobbyist
B
Joined: May 2010
Posts: 28

Say say, I was looking around that webpage you pointed me to JonK and found this.

http://www.dakmart.com/p11038/Denon-AVR-...oduct_info.html

Value wise it is not better than the one you pointed me to but it allows me to grow my system, also I read in a 5.1 configuration you can double amp two main speakers, so if I got an m60 or something it might be able to provide it with some more juice anyway.

do you think that one or save cash and go for the 589?

Re: How would I build an axiom home theatre for 1kish?
Bakajon #308299 05/27/10 08:22 PM
Joined: Dec 2003
Posts: 10,420
J
shareholder in the making
Offline
shareholder in the making
J
Joined: Dec 2003
Posts: 10,420
Depends on your idea of full range. Will they play most notes, yes they can. Will they play thunderous bass notes below 30hz, no they won't and very few speakers will.

Axiom floorstanders would be considered full range for all but the most demanding of low notes in music and HT. The bookshelf speakers are good down to 60-80hz then taper off rapidly which is why a good subwoofer is required to fill in the lack of low frequency response. Most bookshelf speakers produced by any manufacturer operate this way even though some try to say they are full range.


Jason
M80 v2
VP160 v3
QS8 v2
PB13 Ultra
Denon 3808
Samsung 85" Q70
Re: How would I build an axiom home theatre for 1kish?
jakewash #308300 05/27/10 08:26 PM
Joined: Dec 2003
Posts: 10,420
J
shareholder in the making
Offline
shareholder in the making
J
Joined: Dec 2003
Posts: 10,420
The double amp feature does nothing to increase the power output, it simply allows the lower frequencies to be played via the same output wattage that is available to the mids and uppers. It will cost you more in that you also need to buy more wire which is why some call this Buy-wiring (Bi-wire) a speaker.


Jason
M80 v2
VP160 v3
QS8 v2
PB13 Ultra
Denon 3808
Samsung 85" Q70
Re: How would I build an axiom home theatre for 1kish?
jakewash #308305 05/27/10 09:00 PM
Joined: May 2010
Posts: 28
B
Bakajon Offline OP
hobbyist
OP Offline
hobbyist
B
Joined: May 2010
Posts: 28

I see, all good to know. Okay next question.

Do av receivers have non-powered outs? For example I have a powered subwoofer currently, was thinking I could stagger my upgrade if I could run a non powered rca or xlr out to my existing woofer. Just a thought.

Re: How would I build an axiom home theatre for 1kish?
Bakajon #308307 05/27/10 09:18 PM
Joined: Feb 2009
Posts: 3,466
connoisseur
Offline
connoisseur
Joined: Feb 2009
Posts: 3,466
These days most receivers do not have non-powered, pre-amp outputs. That's a feature reserved for higher-end receivers (which are less likely to need external amps, it's a paradox).


Pioneer PDP-5020FD, Marantz SR6011
Axiom M5HP, VP160HP, QS8
Sony PS4, surround backs
-Chris
Re: How would I build an axiom home theatre for 1kish?
Bakajon #308323 05/27/10 10:40 PM
Joined: Dec 2007
Posts: 7,786
axiomite
Offline
axiomite
Joined: Dec 2007
Posts: 7,786
 Quote:
Next question. :P I have a set of bluesky media 2.1's...

If I wanted to could I integrate the satalights into an axiom set up to save cash initially? Here are my current left and right channels.

Was thinking maybe with a splitter they could make a good center channel.

Those are powered speakers. They have an amp built in and so need a low level signal from a pre-am/pre-out. I don't think that you can asign the center or surround channels to pre-outs in a receiver.


Fred

-------
Blujays1: Spending Fred's money one bottle at a time, no two... Oh crap!
Page 3 of 6 1 2 3 4 5 6

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,945
Posts442,477
Members15,617
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 792 guests, and 3 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4