Previous Thread
Next Thread
Print Thread
Rate Thread
Page 2 of 3 1 2 3
Re: Bass Management
Dundas #314547 07/13/10 07:30 PM
Joined: Dec 2006
Posts: 3,569
connoisseur
Offline
connoisseur
Joined: Dec 2006
Posts: 3,569
Originally Posted By: Dundas
Originally Posted By: sirquack
If you have Audyssey turned off, that is ok to reduce the crossover setting, however, you only want to increase the number with Audyssey engaged. Otherwise, you are losing material between what you reduced it to, and Audyssey's results.

I am not sure what you mean by "losing material". I think you will find that when you lower the crossover from what Audyssey suggested that you do not have Audyssey processing in that channel for the frequency range that is below the crossover that Audyssey calculated.


That’s also my understanding that you just don’t get the Audyssey EQ below where the original crossover was set by the receiver. OTOH the LFE channel filter Audyssey applies is suppose to be much “finer” than that of the other channels so theoretically the signals going to the LFE channel are getting “better” EQ. Or like me you can just turn Audyssey off. wink


3M80 2M22 6QS8 2M2 1EP500 Sony BDP-S590 Panny-7000 Onkyo-3007 Carada-134 Xbox Buttkicker AS-EQ1
Re: Bass Management
grunt #314558 07/13/10 08:02 PM
Joined: Mar 2008
Posts: 89
D
old hand
Offline
old hand
D
Joined: Mar 2008
Posts: 89
Originally Posted By: grunt
Or like me you can just turn Audyssey off. wink



But you are using an AS-EQ1 aren't you?

Re: Bass Management
Dundas #314589 07/14/10 01:54 AM
Joined: Dec 2007
Posts: 93
B
bluray Offline OP
old hand
OP Offline
old hand
B
Joined: Dec 2007
Posts: 93
I'm glad I don't have that kind of wizardry with Rotel (I'm not knocking it; I'm sure Rotel didn't want to pay the licensing, and perhaps that savings made my pre/pro a better "value" -- I'm certainly not missing it).

Question: For those with M22s, do you use 60 Hz as a crossover? I do feel my M80s and VP180 work well at 40 Hz, and I like the idea of having a difference no greater than 20 Hz in the handling range of the fronts vs. rears (maybe that's a silly notion). So I'm going with a crossover of either 60 front/80 rear or 40 front/60 rear, but maybe M22s are just ideally suited for the tried and proven default of 80 Hz.

Re: Bass Management
bluray #314591 07/14/10 02:12 AM
Joined: May 2002
Posts: 10,654
shareholder in the making
Offline
shareholder in the making
Joined: May 2002
Posts: 10,654
Blu, when I ran Audyssey, the measurements taken, in co-ordination with the standard set by the receiver manufacturer, resulted in a 60Hz crossover setting. Nevertheless, I wanted the EP500 to do a little more and take more of the lowest bass load off of the M22s, so I manually reset the crossover to 80Hz, which led to excellent sound without sub localization.


-----------------------------------

Enjoy the music, not the equipment.


Re: Bass Management
JohnK #314596 07/14/10 02:32 AM
Joined: Dec 2007
Posts: 93
B
bluray Offline OP
old hand
OP Offline
old hand
B
Joined: Dec 2007
Posts: 93
Makes sense. That's where my head is, too. But then, according to Alan, a head and two ears don't... well, you know.

Re: Bass Management
Dundas #314610 07/14/10 04:25 AM
Joined: Dec 2006
Posts: 3,569
connoisseur
Offline
connoisseur
Joined: Dec 2006
Posts: 3,569
Originally Posted By: Dundas
Originally Posted By: grunt
Or like me you can just turn Audyssey off. wink



But you are using an AS-EQ1 aren't you?


Yes I use the AS-EQ1 which is a form of the Multi-EQ system however, it only works below 200Hz so it doesn’t screw up the rest of the FR range. So when I say that I turn Audyssey off I’m talking about the receiver. If there was a way to only use the LFE curve in my receiver I would do that but Audyssey is all or nothing in my Onkyo 3007 and I don’t even like using the “Flat” curve anymore.

AS-EQ1 does work quite well. However, the LFE EQ on my Onkyo is only marginal at best since its not as robust as the AS-EQ1.


3M80 2M22 6QS8 2M2 1EP500 Sony BDP-S590 Panny-7000 Onkyo-3007 Carada-134 Xbox Buttkicker AS-EQ1
Re: Bass Management
grunt #315189 07/17/10 06:30 PM
Joined: Jun 2008
Posts: 769
aficionado
Offline
aficionado
Joined: Jun 2008
Posts: 769
Is it a good idea to run Audyssey just to see the EQ applied and then switch to manual EQ and actually only use the values calculated by Audyssey for the low frequencies (let's say below 200Hz) and leave the rest un-EQed (0dB).


Bruno
M80s/VP180/QS8s/EP600/AVR-890
------------------------------------
"The problem is choice..."
Re: Bass Management
bdpf #315198 07/17/10 06:52 PM
Joined: Feb 2009
Posts: 3,466
connoisseur
Offline
connoisseur
Joined: Feb 2009
Posts: 3,466
Unfortunately the values shown in the user interface, and those which can be manually entered, are not the whole story. Audyssey, computes and uses other information which you can't manually enter. So it's either use all which Audyssey gives you, or go with the lesser manual settings.


Pioneer PDP-5020FD, Marantz SR6011
Axiom M5HP, VP160HP, QS8
Sony PS4, surround backs
-Chris
Re: Bass Management
ClubNeon #315202 07/17/10 07:20 PM
Joined: Dec 2006
Posts: 3,569
connoisseur
Offline
connoisseur
Joined: Dec 2006
Posts: 3,569
In addition the EQ curve used by Audyssey in general, even more so below 200Hz, uses a finer filter than what is allowed in the manual EQ settings. So even w/o the other information Audyssey uses switching to manual doesn’t even give you the same EQ.


3M80 2M22 6QS8 2M2 1EP500 Sony BDP-S590 Panny-7000 Onkyo-3007 Carada-134 Xbox Buttkicker AS-EQ1
Re: Bass Management
bdpf #315249 07/18/10 01:41 AM
Joined: May 2002
Posts: 10,654
shareholder in the making
Offline
shareholder in the making
Joined: May 2002
Posts: 10,654
Yes, Bruno; as Chris and Dean point out, there's no way to manually duplicate the Audyssey measurements in certain frequency ranges. As Dr. Kyriakakis(with some irritation)points out, the manual parametric equalizer isn't part of Audyssey and is a "crude"(his word) approximation of a small part of the results.


-----------------------------------

Enjoy the music, not the equipment.


Page 2 of 3 1 2 3

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,940
Posts442,457
Members15,616
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 585 guests, and 1 robot.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4