Previous Thread
Next Thread
Print Thread
Rate Thread
Page 1 of 2 1 2
EP-800 energy management suggestions?
#322111 09/12/10 05:38 PM
Joined: Jul 2005
Posts: 67
old hand
OP Offline
old hand
Joined: Jul 2005
Posts: 67
Can anyone recommend a 12V triggered power center or power plug that’s compatible with the EP-800 digital amplifier?

Apparently my power factor correcting Monster HTS 3500 MKII power center isn’t compatible with the digital amplifier in the EP-800. JC suggested I use an outlet with a switch on the wall, which I’m doing for the moment, but I’d like an automated solution to reduce the energy consumption of the EP-800. I’ve already left it running in one case and forgot to turn it on in another.

My EP-800 draws 24 watts in standby mode. This is a bit higher than the stated “under 10 watts” in the manual, but apparently exactly correct for the current version of the amplifier. Axiom apparently updated the amplifier to have it automatically drop to its lowest standby power level when there is no signal. This means the 12V trigger to the sub is now mostly unnecessary unless you get a warm fuzzy from having the LED go from green to red. The standby power draw in either case doesn’t change. Anyway, 24 watts 24/7 adds-up to a measureable increase in the electricity bill each month for no productive reason so I’m looking for an automated solution to turn it completely off when not in use.

Re: EP-800 energy management suggestions?
Montclair #322217 09/13/10 07:00 AM
Joined: Dec 2003
Posts: 10,420
J
shareholder in the making
Offline
shareholder in the making
J
Joined: Dec 2003
Posts: 10,420
Originally Posted By: Montclair

Apparently my power factor correcting Monster HTS 3500 MKII power center isn’t compatible with the digital amplifier in the EP-800.


I take it you are trying to use a 12V trigger out from it or did you have some problems with the sub plugged into the HTS 3500? I have had my sub(not Axiom nor digital) plugged into my Belkin PF60 with out any problems.

Your present solution although not automated is the ultimate in power saving as the sub is completely off and not drawing anypower, I fear any sort of automated solution would be in standby mode and drawing somesort of power. I would suggest looking at changing the switch to an IR switch like for lighting this way it could controlled by your remote and the sub is turned on and off with the rest of the system.


Jason
M80 v2
VP160 v3
QS8 v2
PB13 Ultra
Denon 3808
Samsung 85" Q70
Re: EP-800 energy management suggestions?
jakewash #322219 09/13/10 07:09 AM
Joined: Jul 2006
Posts: 12,077
Likes: 7
C
CV Offline
Founder, Axiom Upgrade Club
shareholder in the making
Offline
Founder, Axiom Upgrade Club
shareholder in the making
C
Joined: Jul 2006
Posts: 12,077
Likes: 7
Good idea, Jay. I'll probably want to do something like that for my subs.

Re: EP-800 energy management suggestions?
jakewash #322484 09/15/10 01:44 AM
Joined: Jul 2005
Posts: 67
old hand
OP Offline
old hand
Joined: Jul 2005
Posts: 67
Interesting idea about an IR lighting switch, Jay.

Any specific manufacturer suggestions? I'm not familar with that equipment.

I didn't try plugging the EP-800 into the electrical outlets on my HTS 3500, but the word from Axiom was that type of power conditioning equipment could damage the amp in the EP-800. I've been waiting too long to get a good sub to risk damaging it first thing. If anyone has first hand experience with the HTS 3500 and the EP-800 that would be helpful.

I'm already using the HTS 3500 for other equipment so I have some small standby power for that, but it was capable of switching off the outlets for the sub amplifier when not triggered by the reciever. Basically, it turned off the light switch automatically for me when I turned off the reciever.

Re: EP-800 energy management suggestions?
Montclair #322497 09/15/10 02:55 AM
Joined: Dec 2003
Posts: 10,420
J
shareholder in the making
Offline
shareholder in the making
J
Joined: Dec 2003
Posts: 10,420


Jason
M80 v2
VP160 v3
QS8 v2
PB13 Ultra
Denon 3808
Samsung 85" Q70
Re: EP-800 energy management suggestions?
jakewash #322563 09/15/10 01:48 PM
Joined: Jun 2007
Posts: 4,357
connoisseur
Offline
connoisseur
Joined: Jun 2007
Posts: 4,357
I have that exact switch in my room and it works very well. I can also control it with my Harmony 1000.


The only reasonable argument for owning a gun is to protect yourself from the police.
Re: EP-800 energy management suggestions?
Ya_basta #322564 09/15/10 01:59 PM
Joined: Aug 2007
Posts: 3,488
Likes: 9
connoisseur
Offline
connoisseur
Joined: Aug 2007
Posts: 3,488
Likes: 9
If you have a Z-Wave compatible device, you can also look at these type of products: http://www.aartech.ca/ha01c-zwave-receptacle-ha01.html.


See Mojo's signature
Re: EP-800 energy management suggestions?
jakewash #322989 09/17/10 03:04 AM
Joined: Jul 2005
Posts: 67
old hand
OP Offline
old hand
Joined: Jul 2005
Posts: 67
The Lutron switch is pretty interesting. I might need that for the lights in my room.

I did find some 12V triggered outlets that are more what I was looking for. They aren’t exactly free, but they all should work well with the EP-800 or any device for that matter. Someone on the AudioCircle.com site asked basically the same question I did. The Xantech product specifies a standby current of 0.24W or almost exactly 1/10th the EP-800 standby current.

Russound ACT-1
Xantech AC1
Niles Audio AC-3

Re: EP-800 energy management suggestions?
Ya_basta #322991 09/17/10 03:11 AM
Joined: Nov 2006
Posts: 1,333
connoisseur
Offline
connoisseur
Joined: Nov 2006
Posts: 1,333
Originally Posted By: wheelz999
I have that exact switch in my room and it works very well. I can also control it with my Harmony 1000.


Ditto. I really like the delay feature. Great WOW factor for visitors who watch you put the remote down and THEN 15 seconds later the lights slowly die off.

Scott


Scott

My HT
Re: EP-800 energy management suggestions?
a401classic #323049 09/17/10 04:57 PM
Joined: Dec 2003
Posts: 10,420
J
shareholder in the making
Offline
shareholder in the making
J
Joined: Dec 2003
Posts: 10,420
I was going to suggest one of these but I thought you wanted to have zero draw.


Jason
M80 v2
VP160 v3
QS8 v2
PB13 Ultra
Denon 3808
Samsung 85" Q70
Page 1 of 2 1 2

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,940
Posts442,457
Members15,616
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 386 guests, and 4 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4