Lots going on from woofers to EQ circuits to cabinets...nothing specific on a model by model basis just yet. Stay tuned!

JohnK is correct. The only change that we have to make from a measurement standpoint is to measure with a microphone at a point equidistant from both woofers. For a subwoofer in a 4-pi environment, like on our outdoor measurement tower, we don't need to be too concerned as the frequencies we are dealing with are omnidirectional anyway.

Thanks Andrew (and JohnK).

New woofer motors eh?

We've started putting a few lab pics up on Facebook showing the subwoofer development (https://www.facebook.com/AxiomAudio). Today was the breadboard shot:

OMG that's going to sound amazing!

Hey, red and green chiclits! Might taste pretty good too.

Where is the blue LED? You can't do a test breadboard without a blue LED and expect us to take is seriously!!

Oh it's there, just out of view in this shot! Blue LEDs are a must on any project board...they seem to have a calming influence when working with tight deadlines.

I'll send you a few and you can report on your tasting.