Get Free, Friendly, Expert Advice
Call 1-888-352-9466 or email

Designed and Manufactured in Canada Since 1980

Axiom Dolby Atmos 7.2.4 Cinema
Solarrdadd's 7.1 Apartment HT!
AxiomAudio Blog

Insider’s Sneak Peek: AxiomAeris

Axiom’s New Computer Speakers

Blind Listening Tests

Who's Online
0 registered (), 53 Guests and 4 Spiders online.
Key: Admin, Global Mod, Mod
Forum Stats
13,399 Registered Members
11 Forums
23,278 Topics
412,505 Posts

Most users ever online: 378 @ 02/24/13 04:33 PM
Top Posters
Ken.C 17964
pmbuko 16378
SirQuack 13358
CV 11520
MarkSJohnson 11245
Meanwhile On Facebook
Topic Options
Rate This Topic
#472 - 11/20/01 11:57 PM Crossover setting
scooby Offline

Registered: 11/20/01
Posts: 1
Hello. I have the M3's and recently purchased a powered sub. What do you recommend as the best low frequency cutoff setting on the sub? I realize this is based on listening, but can you suggest an approximation for matching with the M3's? The speakers will receive the higher frequencies (not the full range), and the sub the low ones. Thanks.

#473 - 11/23/01 07:38 AM Re: Crossover setting
Ian Offline

Registered: 03/13/01
Posts: 847
Any setting above 50Hz will match the M3s if they are getting a full range signal. If your pre-amp is filtering the bass frequencies to the M3s then this would be frequency to set the sub at.

Ian Colquhoun
President & Chief Engineer
Ian Colquhoun
President & Chief Engineer


Moderator:  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Home  |  Corporate Info  |  Products  |  Message Board  |  FAQs  |  Warranty  |  Site Map  |  Privacy Statement   |  Contact Us

©2015 Colquhoun Audio Laboratories Limited
All Rights Reserved.