Axiom Home Page Forums General Discussion Home Theater Has anyone tried Outlaw mono block M200 ?

Thanks everyone.
It's good to hear that you all like M200.I can't wait...
I think i'll go with Dayton cable since i need to order some other stuffs from Partsexpress too.

Anyone try to bi-amp M60 with 4 M200 yet? just curious....I tried bi-amp my denon 3805 by using the method described in Audioholics , but i don't like it very much. There is a slight hum coming from speaker.....well, it's just me.

thanks again.

Hi all,
I got 2 outlaw M200. it works great. Only one complaint is that there is a slight hum from transformer. after open the box, i connect power supply to the unit without connecting any device and I can hear the hum. I don't think this is a ground loop problem since I don't have any other devices connected to the outlet.

Does anyone experience this? And is there a way to prevent or reduce this hum? I hate to send back these amps.

thanks a lot.

Audiofan,

You should give Outlaw a call.
My M200's don't hum. Have you tested the outlet? Or tried another?

Yes, i disconnected all devices, except M200, but the hum is still there. I read this link http://www.6moons.com/audioreviews/outlaw/m200.html

So i'm not sure this is known to every M200 or just some defect that i have.
thanks