Previous Thread
Next Thread
Print Thread
Rate Thread
Page 1 of 2 1 2
Speaker Stands for M60's.
#75606 01/09/05 06:54 AM
Joined: Nov 2004
Posts: 91
old hand
OP Offline
old hand
Joined: Nov 2004
Posts: 91
I wanted to get the forum's opinion on whether putting the M60's on speaker stands would take anything away from the sound? The way my basement is setup, If I lift the speakers off the ground by 12 inches, then I would have the tweeter at the right level. My couch is close to the front speaker and I think I might be missing out on sound.

I found a set of stands at Partsexpress that are 12" tall. The dimenions are 8 3/4 x 9 3/4. The speakers are 15" deep though, so I don't know if they will work or not.

Any advice on this subject would be much appreciated.

Thank you in advance.

Coach


Opt. H31 Denon AVR3803 Denon 2900 Axiom M60'S Axiom VP150 Axiom QS8's x 4 HSU VTF-2
Re: Speaker Stands for M60's.
#75607 01/09/05 07:00 AM
Joined: Apr 2003
Posts: 16,441
shareholder in the making
Offline
shareholder in the making
Joined: Apr 2003
Posts: 16,441
A couple forum members have put the M60s on short stands and found it improved the sound. One of the most effective tweaks you can do is place the speakers so thet the tweeters are at the same level as your ears.

Here's a link to a post by Ajax, who built stands for his speakers.

Re: Speaker Stands for M60's.
#75608 01/09/05 08:19 AM
Joined: Apr 2003
Posts: 5,236
axiomite
Offline
axiomite
Joined: Apr 2003
Posts: 5,236
I had my M60's on stands for a short while. I liked it. Looked odd, but I felt the upper bass cleared up a little bit. (thought even on the floor I think the M60's have some of the clearest bass I've ever heard in a tower speaker)

It certainly won't hurt the sound.



Re: Speaker Stands for M60's.
#75609 01/09/05 01:25 PM
Joined: Sep 2004
Posts: 11,458
shareholder in the making
Offline
shareholder in the making
Joined: Sep 2004
Posts: 11,458
Jack-
Do you have any close-up photos of your M60 stands that you can share?


::::::: No disrespect to Axiom, but my favorite woofer is my yellow lab :::::::
Re: Speaker Stands for M60's.
#75610 01/09/05 02:27 PM
Joined: Dec 2003
Posts: 6,331
axiomite
Offline
axiomite
Joined: Dec 2003
Posts: 6,331
NO!

I'm in "curmudgeon mode" this morning.

I built them before the M60s arrived, and I've always meant to repaint them with a glossy finish to match the M60s, but I've always been able to find an excuse to do something else.

Not being much of a carpenter, I was always fairly proud of these risers, even though no two sides are perpendicular or parallel to each other . UNTIL! A guy over at the av123 forum posted pics of the ones HE built. I may never post pics of mine again.



I didn't feel so badly when I learned that they were made by a forum member who just happens to be a custom cabinet builder.




Jack

"People generally quarrel because they cannot argue." - G. K. Chesterton
Re: Speaker Stands for M60's.
#75611 01/09/05 03:00 PM
Joined: Nov 2004
Posts: 91
old hand
OP Offline
old hand
Joined: Nov 2004
Posts: 91
Thanks for the input, now I just have to find a pair of stands that will hold the speakers.

Any suggestions on retailers?


Opt. H31 Denon AVR3803 Denon 2900 Axiom M60'S Axiom VP150 Axiom QS8's x 4 HSU VTF-2
Re: Speaker Stands for M60's.
#75612 01/09/05 03:07 PM
Joined: Dec 2003
Posts: 6,331
axiomite
Offline
axiomite
Joined: Dec 2003
Posts: 6,331
Well as you alluded, the trick is going to be finding stands that are wide enough, and deep enough, to hold the M60s with stability.

I haven't looked, but you can start here, and here.

Do a goolge search for "speaker stands" and you'll come up with a ton of placees that offer stands.


Jack

"People generally quarrel because they cannot argue." - G. K. Chesterton
Re: Speaker Stands for M60's.
#75613 01/09/05 05:30 PM
Joined: Nov 2004
Posts: 91
old hand
OP Offline
old hand
Joined: Nov 2004
Posts: 91
I measured and figured out that 8" stands would be perfect. But, I found these: http://www.standsandmounts.com/index.asp?PageAction=VIEWPROD&ProdID=659

They are 6" tall,but have a wider platform to place the speaker on.

Any thoughts on these?


Opt. H31 Denon AVR3803 Denon 2900 Axiom M60'S Axiom VP150 Axiom QS8's x 4 HSU VTF-2
Re: Speaker Stands for M60's.
#75614 01/09/05 05:42 PM
Joined: Feb 2003
Posts: 649
aficionado
Offline
aficionado
Joined: Feb 2003
Posts: 649
Well, they certainly look cool...


M22ti mains, EP175 sub, VP150 center, QS4 surrounds
Re: Speaker Stands for M60's.
#75615 01/09/05 08:41 PM
Joined: Nov 2004
Posts: 91
old hand
OP Offline
old hand
Joined: Nov 2004
Posts: 91
I just got done checking out Circuit City, Best Buy, and HHGregg and neither of them had speaker stands that will do the job. I just hate spending that much money for speaker stands. At the same time, those are the only ones with a large platform area. It is not the same size as my speakers, but it is 12", so there would be minimal hangover.
Has anybody purchased items from this retailer before?


Opt. H31 Denon AVR3803 Denon 2900 Axiom M60'S Axiom VP150 Axiom QS8's x 4 HSU VTF-2
Re: Speaker Stands for M60's.
#75616 01/11/05 04:20 AM
Joined: Nov 2004
Posts: 91
old hand
OP Offline
old hand
Joined: Nov 2004
Posts: 91
I ended up going with a pair of stands from "standsandmounts.com" They are the Lovan Jazz600 and they are 159.00! They just look to be the sturdiest of any stands I saw. I found a website that makes custom stands, but I didn't feel it was necessary to spend 440.00 on custom stands. Now, does anybody on this forum make custom stands or know of a more affordable place to purchase custom stands? Should I be worried that my speakers will not fit on those stands flush?

Thanks!


Opt. H31 Denon AVR3803 Denon 2900 Axiom M60'S Axiom VP150 Axiom QS8's x 4 HSU VTF-2
Re: Speaker Stands for M60's.
#75617 01/11/05 05:21 AM
Joined: Mar 2002
Posts: 3,749
Likes: 37
connoisseur
Offline
connoisseur
Joined: Mar 2002
Posts: 3,749
Likes: 37



Enjoy the Music. Trust your ears. Laugh at Folks Who Claim to Know it All.
Re: Speaker Stands for M60's.
#75618 01/11/05 11:51 AM
Joined: Sep 2004
Posts: 11,458
shareholder in the making
Offline
shareholder in the making
Joined: Sep 2004
Posts: 11,458
I had Axiom custom make stands for me. They're called the 350 something or another.... and I guess they really make quite a few of them for some other use.


It's the first speaker stands I've seen that plug in!


::::::: No disrespect to Axiom, but my favorite woofer is my yellow lab :::::::
Re: Speaker Stands for M60's.
#75619 01/12/05 12:14 AM
Joined: Aug 2004
Posts: 6,379
Likes: 7
axiomite
Offline
axiomite
Joined: Aug 2004
Posts: 6,379
Likes: 7
Cool. Another few years and I guess they'll be making digital speaker stands.


M60ti, VP180, QS8, M2ti, EP500, PC-Plus 20-39
M5HP, M40ti, Sierra-1
LFR1100 active, ADA1500-4 and -8
Re: Speaker Stands for M60's.
#75620 01/14/05 05:12 PM
Joined: Jan 2005
Posts: 54
buff
Offline
buff
Joined: Jan 2005
Posts: 54
I have also thought about the 6" stands you purchased. Please post a follow up once you have received them. I am especially interested in the stability of the M60s sitting on these things. How do they look with the M60s on them? Can you post a photo?


--------- NEC 42" Plasma Axiom M60s(x3)/QS4s/M22s Denon 3805/3910 Outlaw 7700 SVS PC-Ultra
Re: Speaker Stands for M60's.
#75621 01/14/05 05:59 PM
Joined: Nov 2004
Posts: 91
old hand
OP Offline
old hand
Joined: Nov 2004
Posts: 91
They are coming all the way from California, and they should get here either today or tomorrow. If they don't come today, I don't think I will get them until Monday. I am going out of town Sunday morning and I will not be back until next Sunday.
Then, I will be more than happy to post pics.


Opt. H31 Denon AVR3803 Denon 2900 Axiom M60'S Axiom VP150 Axiom QS8's x 4 HSU VTF-2
Re: Speaker Stands for M60's.
#75622 01/14/05 06:20 PM
Joined: Dec 2004
Posts: 117
Ned Offline
veteran
Offline
veteran
Joined: Dec 2004
Posts: 117
standsandmount.com racksandstand.com
Both affordable places with lot's to choose from.






Axiom Denon Paradigm SVS
Page 1 of 2 1 2

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,943
Posts442,465
Members15,617
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 845 guests, and 4 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4