amp power rating @ 8 and 4 ohms
|
Joined: Sep 2010
Posts: 8
regular
|
OP
regular
Joined: Sep 2010
Posts: 8 |
hello.
in evaluating amps for 4ohm speakers like the m80, do i look at amp's 4ohm power rating instead of its 8ohm power rating? conversely, do i look at the same amp's 8ohm power rating when matching it with 8 ohm speakers like the m60?
for instance, a stereo amp is rated 250w/550w in 8/4 ohms per channel, respectively. for the m80 (max amp power of 400w at 4ohms), can i say that the amp is more than sufficient to drive the m80's since the amp rated at 550w in 4ohms? for the m60 (max amp power of 250w at 8ohms), do is say that the same amp is just enough?
in relative terms, however, does it mean i have more reserve power using the same amp with m80's than the m60's (550w/400w at 4ohms against 250w/250w at 8ohms).
please enlighten. thanks.
|
|
|
Re: amp power rating @ 8 and 4 ohms
|
Joined: May 2002
Posts: 10,654
shareholder in the making
|
shareholder in the making
Joined: May 2002
Posts: 10,654 |
P, it appears that you're paying too much attention to nominal speaker impedance ratings and also the maximum suggested amplifier power. Speakers vary widely in impedance as frequency varies; for example, the M80 is a 4 ohm speaker over a bit less than half its frequency range. So yes, at those frequencies where it happens to be around 4 ohms, amplifiers face lower resistance and have a higher maximum output capability. The 250w/550w example you give isn't very realistic though, since the theoretical maximum difference is double, and more typical would be about 50% higher into 4 ohms.
Also, the maximum power rating given to a speaker has nothing to do with how much it actually needs, but rather indicates how much it can handle continuously without going up in smoke. Speakers such as the M80s use about 1 watt at a comfortably loud average sound level. Brief split-second peaks in material with a wide dynamic range, such as some classical material, take much more of course, but rarely would need more than the typical 100 watt receiver ratings.
"Just enough" power might be only a few watts for some material, and certainly wouldn't be the maximum advertised suggested amplifier power.
-----------------------------------
Enjoy the music, not the equipment.
|
|
|
Re: amp power rating @ 8 and 4 ohms
|
Joined: Sep 2010
Posts: 8
regular
|
OP
regular
Joined: Sep 2010
Posts: 8 |
thanks for the reply, JohnK. i'm sure your observations are correct. but would you a version that's less "nuanced"? :-) just want a better handle on how "nominal speaker impedance ratings" and "maximum suggested amplifier power" interact, in practical terms. fyi, the example i gave is for the w4s st-500 as posted in www.wyred4sound.com website. thanks!
|
|
|
Re: amp power rating @ 8 and 4 ohms
|
Joined: May 2003
Posts: 18,044
shareholder in the making
|
shareholder in the making
Joined: May 2003
Posts: 18,044 |
Ignore max suggested amplifier power. It's nonsense, in pretty much all cases. Axiom has tested 'M80s with waaaaaay higher power than 400w. As far as impedance and amplifier power go, assuming ideal conditions, 4 ohm ratings would be double 8 ohm ratings. But like John said, you're rarely, if ever, going to get close to that max power in real life. If you are, you probably have A. An extraordinarily large room B. A need for a larger amp. C. Hearing damage
I am the Doctor, and THIS... is my SPOON!
|
|
|
Re: amp power rating @ 8 and 4 ohms
|
Joined: Jun 2008
Posts: 769
aficionado
|
aficionado
Joined: Jun 2008
Posts: 769 |
Out of curiosity, how big is your room?
Bruno M80s/VP180/QS8s/EP600/AVR-890 ------------------------------------ "The problem is choice..."
|
|
|
Re: amp power rating @ 8 and 4 ohms
|
Joined: Sep 2008
Posts: 4,116
connoisseur
|
connoisseur
Joined: Sep 2008
Posts: 4,116 |
hello.
in evaluating amps for 4ohm speakers like the m80, do i look at amp's 4ohm power rating instead of its 8ohm power rating? conversely, do i look at the same amp's 8ohm power rating when matching it with 8 ohm speakers like the m60?
for instance, a stereo amp is rated 250w/550w in 8/4 ohms per channel, respectively. for the m80 (max amp power of 400w at 4ohms), can i say that the amp is more than sufficient to drive the m80's since the amp rated at 550w in 4ohms? for the m60 (max amp power of 250w at 8ohms), do is say that the same amp is just enough?
in relative terms, however, does it mean i have more reserve power using the same amp with m80's than the m60's (550w/400w at 4ohms against 250w/250w at 8ohms).
please enlighten. thanks. This is a well informed article on speaker impedance and its interaction with common receivers. http://www.audioholics.com/education/amplifier-technology/impedance-selector-switch-1
I’m armed and I’m drinking. You don’t want to listen to advice from me, amigo.
-Max Payne
|
|
|
Re: amp power rating @ 8 and 4 ohms
|
Joined: Dec 2003
Posts: 10,420
shareholder in the making
|
shareholder in the making
Joined: Dec 2003
Posts: 10,420 |
As far as impedance and amplifier power go, assuming ideal conditions, 4 ohm ratings would be double 8 ohm ratings. Just to clarify, 4 Ohm amp power is closer to 1.5 times that of the 8 Ohm rating in the real world.
Jason M80 v2 VP160 v3 QS8 v2 PB13 Ultra Denon 3808 Samsung 85" Q70
|
|
|
Re: amp power rating @ 8 and 4 ohms
|
Joined: May 2002
Posts: 10,654
shareholder in the making
|
shareholder in the making
Joined: May 2002
Posts: 10,654 |
P, Ken's reply should be "less nuanced" enough, so I'll just point out that impedance ratings and suggested maximum amplifier power don't "interact"; they have nothing to do with each other. The maximum amp number is essentially meaningless for home use; quality speakers such as Axioms can continuously handle many hundreds of watts without suffering permanent damage, but your hearing can't.
Incidentally, I did take a look at that ST-500 site link. Unless they operate in a world where Ohm's Law doesn't apply, the 550 watt 4 ohm spec is a typo. As was said, the theoretical maximum increase is a double, so possibly the spec was intended to be 500 watts.
-----------------------------------
Enjoy the music, not the equipment.
|
|
|
Re: amp power rating @ 8 and 4 ohms
|
Joined: Sep 2010
Posts: 8
regular
|
OP
regular
Joined: Sep 2010
Posts: 8 |
many thanks johnk and you guys for patiently explaining things. much appreciated.
@bruno - room size is about 6,000 cu. ft.
|
|
|
Forums16
Topics24,943
Posts442,465
Members15,617
|
Most Online2,082 Jan 22nd, 2020
|
|
0 members (),
845
guests, and
4
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|