Onkyo 12v trigger - 04/04/10 12:29 AM
For those with an Onkyo, I have the 707, how do you go about using the 12v trigger. If I read the instructions right I will have to enable zone two just to use the 12v trigger.
Is this right?
For those with an Onkyo, I have the 707, how do you go about using the 12v trigger. If I read the instructions right I will have to enable zone two just to use the 12v trigger.
Is this right?
Re: Onkyo 12v trigger - 04/04/10 12:30 AM
Yes. Onkyo's trigger (for receivers) are typically hard-coded to zone2. My 805 is rigged to be trigged that way (altough I don't use it anymore for that)
Re: Onkyo 12v trigger - 04/04/10 12:52 AM
That's what I figured, thanks Eric.
Re: Onkyo 12v trigger - 04/04/10 01:19 AM
You could still use the trigger for the primary Zone; just tell your macro-remote to turn on Zone2 whenever you power-up.
Re: Onkyo 12v trigger - 04/04/10 01:35 AM
If I can figure out how to add that command to the Harmony it would be nice. No luck yet.
Re: Onkyo 12v trigger - 04/04/10 01:36 AM
I had to make the remote learn it.
Which Harmony are you using?
Which Harmony are you using?
Re: Onkyo 12v trigger - 04/04/10 01:41 AM
The 700
Re: Onkyo 12v trigger - 04/04/10 11:08 AM
Is it able to learn new codes (it is not mentionned on the product description page on logitech.com)
Re: Onkyo 12v trigger - 04/04/10 11:10 AM
I just remembered, I did not learn the code, it was already in the database under "12VTriggerA" which performed Zone 2 power ON as well.
Re: Onkyo 12v trigger - 04/04/10 01:14 PM
I'll have to take a look.
Re: Onkyo 12v trigger - 04/04/10 01:22 PM
Just plug the damn thing in Rick and report back if it blows up.
Re: Onkyo 12v trigger - 04/04/10 01:34 PM
Lol, good advice thar Rick!