Question on HSU VTF-2 MK 2 setup. - 01/01/05 05:56 AM
Looking for some advice again guys
For stereo I have a NAD C320BEE powering M60ti's. I'm looking to get a HSU VTF-2 MK 2 in the near future and need to know how I should hook it up so as to take part of the load off of my little amp.
1. Use the High Level Inputs/Outputs along with the crossover on the sub.
2. Use Y splitters to split the signal from the Pre-Out on the NAD to get two Line Level signals to the sub, and get a High Pass Filter to filter out the bass to the M60s.
3. The same as #2, except without the High Pass Filter.
I'm not sure how each of these differ, only that getting a High Pass Filter means spending more money.
Thanks in advance, and Happy New Year!
-Jon
For stereo I have a NAD C320BEE powering M60ti's. I'm looking to get a HSU VTF-2 MK 2 in the near future and need to know how I should hook it up so as to take part of the load off of my little amp.
1. Use the High Level Inputs/Outputs along with the crossover on the sub.
2. Use Y splitters to split the signal from the Pre-Out on the NAD to get two Line Level signals to the sub, and get a High Pass Filter to filter out the bass to the M60s.
3. The same as #2, except without the High Pass Filter.
I'm not sure how each of these differ, only that getting a High Pass Filter means spending more money.
Thanks in advance, and Happy New Year!
-Jon