Alan,
Thank you very much for the post, unfortunately putting on a ¼” spade isn’t as easy as it sounds.
First you are correct there is a slot on the binding post that will accept a ¼” spade (barely), in fact the spade will fit on one of the posts on the positive side, but not the other.
Secondly there is a cross over between the upper and lower post, this cross over also connects in the same place that the slot is for the ¼” spade. You have to take everything apart, move the cross over above washer (on both posts) while holding the ¼” spade under the washer on the bottom post.
As much as it sounds like I am being critical here, that is not my intention. Just trying to point out my problems with the ¼” spade.
Thanks again for your post.
Del
