After browsing around at all the different specks of speakers, I realized I didn't check into changing the Ohm switch on the back of my receiver after setting up my Axioms. M22ti = 8 Ohm, VP150 = 6 Ohm, QS8 = 6 Ohm. My Yam RXV-2095 has a selection as follows:
setting 1
center 8 Ohm min./speaker
front 8 Ohm min./speaker
rear 8 Ohm min./speaker
main A or B 8
main A & B 16
setting 2
cent 4 Ohm min./speaker
front 6 Ohm min./speaker
rear 4 Ohm min./speaker
main A or B 4 Ohm
main A & B 8 Ohm
I had it on setting 1 and switched it over to setting 2. What was this doing to my receiver while it has been on setting 1 for the last two months? I didn't notice a difference after switching it to setting 2, should I? Will I get more power or volume with the correct setting to speakers. Are my amps working harder on this lower Ohm setting?
