Re: Very Simple Question
|
Joined: Apr 2005
Posts: 1,155
connoisseur
|
OP
connoisseur
Joined: Apr 2005
Posts: 1,155 |
The Rat.
M80s, VP-150, QS8s,
SVS PC 20-39+, OPPO,
Onkyo 703s, Harmony 880
Sony 60" SXRD HDTV
|
|
|
Re: Very Simple Question
|
Joined: Apr 2005
Posts: 1,155
connoisseur
|
OP
connoisseur
Joined: Apr 2005
Posts: 1,155 |
izub: thanks! I had not read that article. It answered some but not all of my question. Ironic that I would ask the question and there be this month's article on it! LOL!!
In so many words, I think that he said that the dB scale is referenced to nothing, and there is no standard!
I am sort of lost in the last part of the narrative where he recommends the receiver setting at 80 dB and then talks about the master setting of -10 to -15 dB and the then each channel to + 3 dB.
I think that a far simpler way (since all things appear relative) is to set your master volume such that your meter reads 80 dB SPL. Then go in to the individual channel set up and see what the readings are with pink noise. Take the highest channel reading and set all the rest to it.
Comments???
The Rat.
M80s, VP-150, QS8s,
SVS PC 20-39+, OPPO,
Onkyo 703s, Harmony 880
Sony 60" SXRD HDTV
|
|
|
Re: Very Simple Question
|
Joined: Jan 2005
Posts: 2,034
connoisseur
|
connoisseur
Joined: Jan 2005
Posts: 2,034 |
Had you stayed in class a bit longer you would have learned that the technology began with the installation of insullating adhesives on hot liquid vessels, AND yes, the removal of said tapes and the resulting laminar Delta Ts evolving into, well,...you guessed it....Thermoductionivity!
|
|
|
Re: Very Simple Question
|
Joined: Jan 2002
Posts: 3,270
connoisseur
|
connoisseur
Joined: Jan 2002
Posts: 3,270 |
Hi RatPack,
It's really complicated and there is no direct comparison possible from the volume dB display on your receiver, which is referring to electrical changes in dB (it takes 10 times as much amplifier power in watts to increase volume levels so they subjectively sound "twice as loud") and actual acoustic Sound Pressure Levels (dB SPL) at your listening area as measured by the Rat Shack SPL meter.
If engineers were observing strict theory, they would calibrate the volume dB display (assuming speakers of a given sensitivity) so that when you cranked up the control to the "0 dB" setting, the amplifiers would be ready to clip. The amplifiers would be producing their maximum rated output just before distortion set in. But loudspeakers vary considerably in their rated sensitivity (how efficiently they convert electrical watts to acoustic output), which will affect how much power is drawn from the receiver.
You can't compare the dB readouts from one brand of receiver to the next. There is a consensus, however, that most engineers calibrate the volume display so that the amplifiers will be nearing their maximum output somewhere between -10 dB and +5 dB on the display. What that translates to in actual volume levels in acoustic dB, C weighting scale, measured on the Rat Shack dB meter at your listening seat in your particular room will depend on a host of variables: 1) the rated sensitivity of the speakers 2) the absorptive or reflective qualities of the room and its furnishings 3) the physical dimensions of the room 4) how far away from the speakers you are sitting 5) How many speakers are operating (just stereo, 5.1, 7.1) from the same A/V receiver, and other variables too numerous to go into.
In the days of analog recording and broadcasting, "0 dB" or "+3 dB" indicated when the signal being recorded (or broadcast) was at near-distortion levels. Analog tape recorders "clipped" fairly softly, so you could push recording peaks beyond 0 dB to +3 dB or more without gross audible distortion. The "0 dB" reading was a means of standarizing recording levels on tape among different studios, and also of preventing radio and TV station transmitters from overmodulating (distorting).
But digital recorders clip in a nasty fashion and you must never let the recording signals get so loud that they go over 0 dB on the input meters. Even so, it still happens.
I hope this is somewhat clearer. If you have everything set up OK with all your relative channel levels, and you are using speakers of average or better rated anechoic sensitivity (89 or 90 dB/1 watt/1 meter), then you can assume that by the time your volume dB display gets to the -10 dB setting or higher, things will be getting very, very loud and the amplifiers may be nearing their full rated output on peaks.
Finally, if your receiver display indicates "-30 dB", you can assume that you are quite a ways from pushing the receiver's amplifiers into distortion.
Regards,
Alan Lofft, Axiom Resident Expert (Retired)
|
|
|
Re: Very Simple Question
|
Joined: Apr 2005
Posts: 1,155
connoisseur
|
OP
connoisseur
Joined: Apr 2005
Posts: 1,155 |
Thanks Alan! That was a great explanation.
I don't think that I have ever had my receiver past the -17 dB level (whatever power level that may be), and that was more than plenty loud for me.
I appreciate your technical input!!!!!
The Rat.
M80s, VP-150, QS8s,
SVS PC 20-39+, OPPO,
Onkyo 703s, Harmony 880
Sony 60" SXRD HDTV
|
|
|
Re: Very Simple Question
|
Joined: Apr 2005
Posts: 2,339
connoisseur
|
connoisseur
Joined: Apr 2005
Posts: 2,339 |
ROTFLMAO
I'm sorry but you lost me with this one.
|
|
|
Re: Very Simple Question
|
Joined: May 2003
Posts: 18,044
shareholder in the making
|
shareholder in the making
Joined: May 2003
Posts: 18,044 |
Rolling On The Floor Laughing My Ass Off
I am the Doctor, and THIS... is my SPOON!
|
|
|
Re: Very Simple Question
|
Joined: Apr 2005
Posts: 1,155
connoisseur
|
OP
connoisseur
Joined: Apr 2005
Posts: 1,155 |
Alright you two, what was so funny about my post???
Maybe I should take up comedy?
The Rat.
M80s, VP-150, QS8s,
SVS PC 20-39+, OPPO,
Onkyo 703s, Harmony 880
Sony 60" SXRD HDTV
|
|
|
Re: Very Simple Question
|
Joined: Sep 2004
Posts: 11,458
shareholder in the making
|
shareholder in the making
Joined: Sep 2004
Posts: 11,458 |
Rat:
I think he was quoting YOU higher up where YOU wrote ROTFLMAO.
::::::: No disrespect to Axiom, but my favorite woofer is my yellow lab :::::::
|
|
|
Re: Very Simple Question
|
Joined: Feb 2005
Posts: 86
old hand
|
old hand
Joined: Feb 2005
Posts: 86 |
See all the problems I've caused?! NO SOUP FOR ME, ONE YEAR!!
Professional Axiom Lurker
|
|
|
Forums16
Topics24,945
Posts442,484
Members15,617
|
Most Online2,082 Jan 22nd, 2020
|
|
2 members (Hambrabi, rrlev),
438
guests, and
4
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|