Polk SDA 1C VS M80 V3
|
Joined: Feb 2011
Posts: 134
veteran
|
OP
veteran
Joined: Feb 2011
Posts: 134 |
I have an old set of Polk SDA 1C's, very good speakers, but to make a long story short, It's time to upgrade. This is a stereo system only.
I'm looking at the M80V3 to replace them. I listen to mostly classic rock, blues, and classical. Let me say i do listen at concert volumes to put it mildly. They would be sitting in a room about 15x27. The speakers would be about 8-9 feet apart. The ceiling is a dropped type with standard acoutical 2x4 tiles, carpet on the floor.
The equipment to run this is an Onkyo M-504 Dual mono block, Jolida 100A and an Adcom pre. I don't always sit in the "sweet" spot and could be any place in the room, as there is a bar at the end of the room. My question would be, can the M80 put out enough "sound" to fill the room, and can they handle the volume rquired, without adding extra speakers to the mix. Thanks for any input on this Bob
Last edited by bobt; 02/06/11 02:19 PM.
|
|
|
Re: Polk SDA 1C VS M80 V3
|
Joined: Feb 2005
Posts: 5,211
axiomite
|
axiomite
Joined: Feb 2005
Posts: 5,211 |
Yes the M80s will fill your room and then some, our room (14x25) is about the same size as yours and I've never felt like the M80 were never up to the task. You'll have have more speaker than your ears will probably allow for any length of time.
Welcome!
|
|
|
Re: Polk SDA 1C VS M80 V3
|
Joined: Jan 2004
Posts: 13,849 Likes: 15
shareholder in the making
|
shareholder in the making
Joined: Jan 2004
Posts: 13,849 Likes: 15 |
The M80's can go way beyond your needs, if you don't go deaf first. Welcome by the way. Most likely you don't have anough power to drive them anyway.
M80s VP180 4xM22ow 4xM3ic EP600 2xEP350 AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85
|
|
|
Re: Polk SDA 1C VS M80 V3
|
Joined: Feb 2011
Posts: 134
veteran
|
OP
veteran
Joined: Feb 2011
Posts: 134 |
Thanks for the welcome. I've been a musicain for 30 years, playing Marshall 1/2 stacks on stage, so if i'm not deaf yet, probably will not happen..LOL The Onkyo M-504 is a high current dual mono block that puts out about 170wtts per at 8 ohms..at 4, more like 250. Never had a problem driving any speaker before. Are the M80's power hogs?
|
|
|
Re: Polk SDA 1C VS M80 V3
|
Joined: Sep 2004
Posts: 11,458
shareholder in the making
|
shareholder in the making
Joined: Sep 2004
Posts: 11,458 |
No, they're efficient/sensitive. Welcome to the forums! I will say that when I quickly read your subject line, I thought this thread was someone searching for Polka SACDs.
::::::: No disrespect to Axiom, but my favorite woofer is my yellow lab :::::::
|
|
|
Re: Polk SDA 1C VS M80 V3
|
Joined: Jan 2004
Posts: 13,849 Likes: 15
shareholder in the making
|
shareholder in the making
Joined: Jan 2004
Posts: 13,849 Likes: 15 |
I would not say they are power hogs, actually they are very efficient and can play very loud using little power, rated at 95dB inroom 1watt/meter. I don't exactly remember the specs, but I think Axiom has tested them before in the lab pumping wattage hungry music at 700+ watts continously with peaks exceeding 1K watts for 24-48+ hours.
M80s VP180 4xM22ow 4xM3ic EP600 2xEP350 AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85
|
|
|
Re: Polk SDA 1C VS M80 V3
|
Joined: Feb 2011
Posts: 134
veteran
|
OP
veteran
Joined: Feb 2011
Posts: 134 |
My other question would be , how big of a "soundstage" do these present. The Polks SDA's are very good at that, present a very open type soundstage. It's always nice to sit at the "sweet" spot to pick up every little thing. But if your at the other end of the room. Will the m80's present you with an open, type "spacial" feeling. for lack of better words..
|
|
|
Re: Polk SDA 1C VS M80 V3
|
Joined: May 2003
Posts: 18,044
shareholder in the making
|
shareholder in the making
Joined: May 2003
Posts: 18,044 |
The M80s have a fantastic soundstage and imaging. HA! Just looked up the Polks. Now no one gets to say that no other speaker from a reputable manufacturer used dual tweeters.
Last edited by kcarlile; 02/06/11 03:45 PM.
I am the Doctor, and THIS... is my SPOON!
|
|
|
Re: Polk SDA 1C VS M80 V3
|
Joined: Jan 2002
Posts: 3,270
connoisseur
|
connoisseur
Joined: Jan 2002
Posts: 3,270 |
Hi bobt,
You'll find the M80s will present a very wide and deep soundstage (if the source material is well recorded); in addition, the M80s will be much more transparent and musically accurate than the old Polks.
Are those Polks of yours one of the models that used the cross-cancellation circuitry to expand the soundstage? That effect could be quite compelling or bizarre, but it only worked well if you were precisely in the sweet spot between the two speaker. The effect collapsed if you were anywhwere off-axis or even turned your head at an angle.
And, as others have noted, the M80s will cleanly handle many hundreds of watts per channel and deliver SPLs that are extremely loud, if desired.
Regards, Alan
Alan Lofft, Axiom Resident Expert (Retired)
|
|
|
Forums16
Topics24,984
Posts442,691
Members15,643
|
Most Online2,699 Aug 8th, 2024
|
|
0 members (),
595
guests, and
0
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|