Get Free, Friendly, Expert Advice
Call 1-866-244-8796 or email

Designed and Manufactured in Canada Since 1980


AxiomAudio Blog

Positioning Floorstanding Speakers

Our Newest Flagship Model: The M100

Why We Make Our Own Drivers

Wall'O'Fame
"Serenity Cinema", now with 40% extra Serenity!
Updated as requested.
Who's Online
5 registered (MarkSJohnson, BobKay, CV, tomtuttle, medic8r), 106 Guests and 10 Spiders online.
Key: Admin, Global Mod, Mod
Financing
Forum Stats
12711 Members
11 Forums
22686 Topics
400521 Posts

Max Online: 378 @ 02/24/13 04:33 PM
Top Posters
Ken.C 17696
pmbuko 16225
SirQuack 13311
CV 11062
MarkSJohnson 10680
Meanwhile On Facebook

8| Don't miss Andrew Welker's post on our message boards about the new subwoofer...

󾓲 The April Newsletter is out! Did you get your copy? http://www.axiomaudio.co...

Double-take! :O How well do you know our line? First one to spot the surprise...

Page 2 of 2 < 1 2
Topic Options
Rate This Topic
#392731 - 05/05/13 07:42 AM Re: Upgrade AudioBytes Speakers to M2? [Re: jmone]
jmone Offline
veteran

Registered: 01/08/06
Posts: 148
Loc: Sydney Australia
So - any suggestions on a "small" amp/receiver to drive a 2.1 speaker system to fill a small room?


Edited by jmone (05/05/13 07:42 AM)
_________________________
HT:M80s,VP150,QS8,EP500 Outside:2 Pair M3 1 Pair M22 Office:AudioBytes, Games Room: M60,VP150

Top
#392747 - 05/05/13 10:53 PM Re: Upgrade AudioBytes Speakers to M2? [Re: jmone]
JohnK Offline
shareholder in the making

Registered: 05/11/02
Posts: 10307
The use of "fill" indicates that you may want a much higher sound level than is used while at the computer. It also may help to explain why three Audiobyte drivers have gone down. What did Axiom suggest was the problem(and were they mid-woofers, tweeters or both?)? You may have simply been playing them at a level well beyond what the amplifier(intended for typical computer speaker use)could handle without clipping and damaging the drivers.

If the lower sound level which is safe isn't adequate for all your uses, then yes, a bigger and more powerful setup would be needed. I'd strongly suggest a multi-channel HT receiver even if you're only considering 2.1 use now. The bass management to cross over the sub and speakers(which almost no 2-channel receivers have)is a substantial plus and the economies in producing these units in quantity result in getting more for a similar amount of money compared to stereo units.

I've visited Sydney, but know almost nothing about the Australian audio equipment market. I took a look at a Sydney dealer here for the sort of unit I might suggest, but was appalled at the price, which at about $460 USD was about twice what would be paid in the U.S. Possibly shipping and other charges involved in your buying from the U.S. would almost wipe out any savings. In any case, I'd suggest an Onkyo or Denon 5.1 model in the 80 watt or above class, or if you get just a stereo unit, the HK-3390 would be suitable.
_________________________
-----------------------------------

Enjoy the music, not the equipment.



Top
#392759 - 05/06/13 02:42 AM Re: Upgrade AudioBytes Speakers to M2? [Re: jmone]
jmone Offline
veteran

Registered: 01/08/06
Posts: 148
Loc: Sydney Australia
Thanks John. I'm comfortable with the flexibility and power of the AVR approach for the reasons suggested but just don't like the physical presence for a Study. And yes we pay inflated prices down under but I could just get a second hand AVR (without any fancy Video Processing as these older HDMI units are now cheap as chips).

I've had lots of toing and froing with Axiom over this system trying to work out why I've blown 3 x "mid woofers" on the Sat and never the Tweeters or the drivers in the Sub. Axiom suggested that the system should be able to play at full vol from the included Audiobyte amp and that it must be distortion in the input but.....now I just play at lower sound pressure levels. (note: I'm also on my second amp - the first one had a bad hum to it. I've also removed the flying remote as this introduced a hum as well a certain positions.... + I replaced all the supplied cables with shielded / ferrite baluns and they made a big improvement removing hum) and so far so good. I'm just nervous of "Cranking" it up, hence the Q on the upgrade path. Given the full AVR alternative I may just enjoy what I have yet!
_________________________
HT:M80s,VP150,QS8,EP500 Outside:2 Pair M3 1 Pair M22 Office:AudioBytes, Games Room: M60,VP150

Top
#392760 - 05/06/13 03:11 AM Re: Upgrade AudioBytes Speakers to M2? [Re: jmone]
jmone Offline
veteran

Registered: 01/08/06
Posts: 148
Loc: Sydney Australia
Another thought - on my PC I can also do full Bass Mgt in SW (I use JRiver Media Center) so a small 2ch amp + active sub would also be fine....
_________________________
HT:M80s,VP150,QS8,EP500 Outside:2 Pair M3 1 Pair M22 Office:AudioBytes, Games Room: M60,VP150

Top
#392940 - 05/09/13 06:55 AM Re: Upgrade AudioBytes Speakers to M2? [Re: jmone]
jmone Offline
veteran

Registered: 01/08/06
Posts: 148
Loc: Sydney Australia
I've ordered another set of Algonquin for the 2.0 part (as I can redeploy them outside if needed). Say I drive the new setup with an AVR or dedicated mono blocks, can I use the AudioBytes Sub as the 0.1 with them or is the lack of cross over going to be an issue?
_________________________
HT:M80s,VP150,QS8,EP500 Outside:2 Pair M3 1 Pair M22 Office:AudioBytes, Games Room: M60,VP150

Top
#392941 - 05/09/13 07:23 AM Re: Upgrade AudioBytes Speakers to M2? [Re: jmone]
Ken.C Offline
shareholder in the making

Registered: 05/03/03
Posts: 17696
Loc: NoVA
You probably won't be able to use the sub with them, either. Sorry!
_________________________
I didn't do it, no one saw me, you can't prove anything.

Top
#393238 - 05/17/13 11:37 PM Re: Upgrade AudioBytes Speakers to M2? [Re: jmone]
doormat Offline
devotee

Registered: 10/28/07
Posts: 395
Loc: Cold Lake, AB
On the plus side M3s do sound excellent without a sub. I used M2s for a while as computer speakers and even with a sub found them lacking (though they were very clear and precise, just "lacking" that certain je ne sais quoi). I now use M22s for the computer with a sub and love them. My M3s serve as a standalone 2.0 system in the bedroom and I love them as well.
_________________________
M80s/VP160/QS8s/EP350; M22s; M3s.

Top
Page 2 of 2 < 1 2



Moderator:  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Home  |  Corporate Info  |  Products  |  Message Board  |  FAQs  |  Warranty  |  Site Map  |  Privacy Statement   |  Contact Us

©2014 Colquhoun Audio Laboratories Limited
All Rights Reserved.