will it work

Print Thread

Rate Thread

Haoleb how you doing short note #20742 09/27/03 09:27 PM
Joined: Sep 2003 Posts: 3 A AllNew OP newbie
OP AllNew newbie A Joined: Sep 2003 Posts: 3	i was thinking i could double the power in bridge mode hooked to the m80s with the c370 and 270 however nad only recomends 8 ohm speakers to do so why is this if the amp can handle 2 ohm loads bye just wondering want to make sure of all my options if i plan on spending all this money lol Thank you for your recent request via the NAD Electronics web-site. I spoke with technical services regarding your questions, and here is their input: The C370 should not be bridged with 4 ohm speakers at high levels. 4 ohm speakers look like 2 ohms to a bridged amplifier, and it will therefore over - heat and shut down. Best regards, Karen Pritchard (dc)

Entire Thread
Subject	Posted By	Posted
will it work	AllNew	09/24/03 11:24 PM
Re: will it work	Haoleb	09/25/03 12:21 AM
Re: will it work	OGS20	09/25/03 02:37 AM
Re: will it work	Ken.C	09/25/03 02:45 AM
Re: will it work	Haoleb	09/25/03 02:54 AM
Re: will it work	Ken.C	09/25/03 02:57 AM
Re: will it work	JohnK	09/25/03 03:02 AM
Re: will it work	Wid	09/27/03 06:32 PM
Re: will it work	Haoleb	09/27/03 08:46 PM
Re: will it work	Haoleb	09/27/03 08:48 PM
Haoleb how you doing short note	AllNew	09/27/03 09:27 PM
Re: Haoleb how you doing short note	Haoleb	09/27/03 11:09 PM
Re: will it work	rcvecc	09/28/03 03:24 AM
question for you rcvecc	AllNew	09/28/03 04:45 AM
Re: question for you rcvecc	rcvecc	09/28/03 01:55 PM
Re: question for you rcvecc	Haoleb	09/28/03 06:12 PM
Re: question for you rcvecc	JohnK	09/29/03 05:45 AM
Re: question for you rcvecc	pmbuko	09/29/03 05:50 AM