Axiom Home Page Forums General Discussion Home Theater Weak Sub Output

Hey folks. I'm trying to correct the weak signal from my
receiver's mono out to the sub. With a line level connection it's extremely weak and only somewhat improved with a Y connector. The only way I've been able to get any decent output is with speaker level connections. I have a pretty old 5.1 receiver (Onkyo TX SV424). Curiously, the remote has center/rear adjustment buttons, but nothing for fronts/sub. What gives?

Are you using a good, thick cable for the sub? When I first got mine I thought it was weak, and then I upgraded cables and it was like night and day.

Looks like a pretty standard cable to me. What did you upgrade with/to?

I used a generic rca cable until I hooked up a Monster Cable sub cable. I'm not sure on the model number but I've seen it at best buy.

I'll check it out. Thanks.

Astav, you didn't identify the sub, but any sub with its own amp doesn't receive any power over either the line level or speaker level connections, so the cable(unless it was totally broken)shouldn't be the problem. I assume that you tried turning up the level control on the sub. If the added voltage using the Y-connector helped, then you need still more voltage from the sub output on the receiver. I'm not familiar with your receiver, but any receiver with a line-level sub output has to have a provision for changing the level of that output. The owners manual should at least briefly discuss the point.

What kind of sub is it? Have you tried adjusting the gain(volume) on the sub itself?

John K. Unfortunately I can't find the manual. I've contacted Onkyo for a replacement but haven't heard back from them. Maybe there is some Jedi remote feature I haven't discovered yet. I'll keep at it...

It's a Klipsch Ksw 12

That's funny, im listening to that same sub right now. It's plently loud for me.