Axiom Home Page Forums General Discussion Advice from Axiom Owners Short speaker stand for Axiom M80

I would measure it if I can. I am currently in China and don't have the speaker with me. As mentioned before, I wanted to get it made while I am here. I could measure it when I return and have it made next time I am back in China.

I did try to contact Axiom. No response to my request. So I am stuck right now until I return to the US or some provide me some information. I have tried to search around for this information and have no luck. I will try again.

Johny

Check back later today/tonight and I will see if I can find some time to do a measure for you.

Jason,

Were you able to get those dimensions? I would really appreciate if you can. Thank you.

Johny

I see some spare time tonight( been very busy putting the backyard back together after some recontruction to remake our patio). I shall try to rememebr tonight. I even wrote it down on my to do list for today.

The screw size is 1/4"-20

Guys,

I want to post some images. But I don't know how.

Johny

Ft spacing is 6.25" and rear is 4.75" on center, but I would go with a slotted hole to allow for minor variances.

To post an image, your picture must be online somewhere, like photobucket or any other web service. Then you can show it in your post by putting [img] and [/img] around the link to the image.