Axiom Home Page Forums General Discussion Home Theater Swapped M22's for M60's, Need a little help.

That's audio to you: the smaller the frequency, the larger the speaker!

I think he does, yes.

Are you sitting in a null? Does moving the speakers position change your assessment? Do you live in New Hampshire?

oh yeah, thanks for the catch. Also, make sure your bypassing the crossover on the sub, since the receiver is doing the management. :0

Since the M60s have rear ports I would also ensure that there is enough space behind the speakers. You may have to try several distances to determine what sounds best!

I checked the amp on the sub and it is set for
Crossover Frequency (Knob) 90Hz
Crossover: "Out"

I am not sure about the crossover set to "out" or not. I read somewhere at HSU that maybe it should be set to "IN", it was a while back so I don't remember exactly.
The back of the speaker is a little over a foot from the wall. This weekend I am going to watch a couple of movies that I'm familiar with and turn the EQ off and see if that makes a difference. On a little different note I read on a AVS/Audyssey Thread that the LFE should be set to 120Hz, NOT 80Hz. Now this thread was pertaining to calibrating with Audyssey. Just wanted to through that out there....

With the Hsu the crossover should be set to out. It shouldn't matter as to the position of the crossover dial.

Not to get completely off subject but here is the quote on the 120Hz for the sub.

"B. Raise the low-pass filter setting (usually incorrectly identified as a crossover) of the LFE subwoofer in the receiver / processor to 120Hz, if allowed."

Again this pertains to the Audyssey Setup.

Ok, thanks I could not find the thread.