M60s in cabinet?
|
Joined: May 2010
Posts: 1
newbie
|
OP
newbie
Joined: May 2010
Posts: 1 |
I'm about to buy a pair of M60v2s for my new home. I, of course, would like to just set them on the living room floor, but as part of the Wife Appeasement Factor, have agreed to put then into the wall cabinets. My plan was to set them in cabinets without their own floor, so that they were actually set on the real floor, with speaker cloth covering the front (and when I really wanted to listen, open the cabinet doors and pull the speakers out!). As it turns out, this is more complicated than I thought. It is not just the cabinet, but the kick plate below that has to have at least 15" interior space to accommodate these speakers. I don't have that much room; I only have a total of 15". This means putting the speakers in the cabinet--up on the cabinet floor, which is a couple of inches off the real floor. How much of a problem is this? Am I just going to be vibrating that whole wall of cabinets (and the bookshelves above)? Any suggestions?
|
|
|
Re: M60s in cabinet?
|
Joined: Dec 2003
Posts: 10,420
shareholder in the making
|
shareholder in the making
Joined: Dec 2003
Posts: 10,420 |
The in-cabinet M60s are meant to be set on the floor of the cabinet as the front baffle extends beyond the bottom of the speaker base. The speakers were designed to have the front baffle protrude in front of the cabinet it is mounted into as that front baffle has a lip all the way around for a slightly proud placement in the cabinet.
Jason M80 v2 VP160 v3 QS8 v2 PB13 Ultra Denon 3808 Samsung 85" Q70
|
|
|
Re: M60s in cabinet?
|
Joined: Dec 2008
Posts: 6,928
axiomite
|
axiomite
Joined: Dec 2008
Posts: 6,928 |
Don't the in-cab's come with some isolation padding to go underneath the cab/support?
Half of communication is listening. You can't listen with your mouth.
|
|
|
Re: M60s in cabinet?
|
Joined: Jan 2002
Posts: 3,270
connoisseur
|
connoisseur
Joined: Jan 2002
Posts: 3,270 |
Hi Jauchart, Your plan is to get regular floor-standing M60s, not our dedicated in-cabinet M60s that are designed for in-cabinet mounting, correct? If you recess regular M60s into an enclosure in a cabinet, it will change the tonal balance, usually in a negative way, because of the reflections and diffractions caused by the surrounding cabinetry. We designed the in-cabinet M60s to overcome many of those problems. I think Jakewash misunderstood your question. If the WAF means the speakers will be inside the cabinet much of the time, you should get the in-cabinet models, which also use a big front-mounted port to avoid the loading problems that rear-ported speakers may have if they're recesssed into cabinetry. http://www.axiomaudio.com/m60-in-cabinet.html Regards,
Alan Lofft, Axiom Resident Expert (Retired)
|
|
|
Re: M60s in cabinet?
|
Joined: Dec 2003
Posts: 10,420
shareholder in the making
|
shareholder in the making
Joined: Dec 2003
Posts: 10,420 |
I was thinking about using in-cabinet versions from the start.
I am unsure as to whether or not the in-cabs come with some sort of isolation pads, I think they do. If not, buying some elsewhere is not that difficult. Hopefully the few forum mambers that have in-cabs will be along or Alan might drop back in.
Jason M80 v2 VP160 v3 QS8 v2 PB13 Ultra Denon 3808 Samsung 85" Q70
|
|
|
Re: M60s in cabinet?
|
Joined: Jan 2004
Posts: 13,840 Likes: 13
shareholder in the making
|
shareholder in the making
Joined: Jan 2004
Posts: 13,840 Likes: 13 |
you would be better off considering the "in-cabinet" version of the m60's, otherwise you will be sacrificing performance.
M80s VP180 4xM22ow 4xM3ic EP600 2xEP350 AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85
|
|
|
Re: M60s in cabinet?
|
Joined: Jan 2010
Posts: 110
veteran
|
veteran
Joined: Jan 2010
Posts: 110 |
I have In cabinets, they do have rubber on bottom, I put them in a wall, about a foot above floor. I've never been able to compare them to a non in cabinet version from axiom, but my cabinet 60s are awesome.
|
|
|
Re: M60s in cabinet?
|
Joined: Jan 2010
Posts: 110
veteran
|
veteran
Joined: Jan 2010
Posts: 110 |
To add... I think they sound better raised a bit. That has an extra plus of putting the mid woofer closer to the middle of my flat screen.
I have not noticed any cabinet vibration. I have felt none. And as Alan mentioned, the crossovers were designed for cabinet to be in-line with the wall. So I would not worry about pulling the out of cabinet when the wife is away!
|
|
|
Re: M60s in cabinet?
|
Joined: Jun 2010
Posts: 33
enthusiast
|
enthusiast
Joined: Jun 2010
Posts: 33 |
Anyone have any recommendations for a/v furniture to put the in-cabinet m60s in along with the LCD and receiver, etc?
|
|
|
Forums16
Topics24,945
Posts442,482
Members15,617
|
Most Online2,082 Jan 22nd, 2020
|
|
0 members (),
682
guests, and
3
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|