Hi, Joe and I were talking previously about using two VP150's from above and below a screen to get around the concerns having a center channel behind.
He mentioned that since the two speakers would need to run parallel you'd be putting a 3ohm load on your receiver instead of the standard 6 ((6*6)/(6+6)=3). Due to this you'd then need a seperate amp to power your center channels.
Is this the sort of thing I would need to accomodate this?:
Model 200 M-Block Amplifier
It's a "single channel amp" and although I don't know much about them this would be to amplify only one channel right? Which is what the parallel VP150's would function as?
-Nick
P.S. Not saying this is the best choice for one of these..just wondering if it's the right type.