Free,
I followed someone's advice on here (I have read so many posts in the past week that I don't remember who) and downloaded the manual for the 2600. I looked at the areas in the Table of contents to answer some questions about crossover but did not see the answer. Can you set independant crossovers for each speaker? In otherwords could I set the surrounds at 80 but the fronts at 60? Also in reading the manual, it said that I should set the receiver for either 6 ohm or 8 ohm speakers up front. How would I handle have M60 8 ohm fronts and QS8 6 ohms on the rear? Not that I have them yet, but I have great plans.
