Your desciption sounds like it was done correctly, but you had stated that you had the ground and neutral under the same screw and that should never happen.
Quote:
The two lines I ran, 20amp HT breaker and 15amp light/outlet breaker were done similar, however, I did place the ground and neutral under the same screw. I may recheck those and/or seperated them to their own screw. I've heard it is important those screws are tightened down good.
I would say this could be the problem.
The neutral should be on the side of the receptacle with the longer prong opening and the power on the other side and the ground ,bare wire, connected to the box at least, and the ground screw on the receptacle.
Look here
Last edited by jakewash; 01/13/07 11:02 PM.
