you could make another plate for on the bottom and a little wider. Just cut 2 " strips 45 degree angle and screw them on the bottom so they protrude 1" or so wider on the front and sides. Then cut a square piece a little wider than the base again and router a nice edge on it. It would give you 1.5" more hieght a little more stable and look nice.
BTW.. they look nice I made a set a few years back with MDF and painted it black and put the high gloss coating to them. I may end up making them again for my son
Last edited by axiom_man; 03/14/07 04:40 PM.
