Axiom Home Page Forums General Discussion Technical Questions Where is the weak link?

If the speakers do not buzz when hooked to the receiver (assuming you used the same speaker wire to do this) then it is an electrical problem from the pre-amp to the main amp or the main amp itself. This sort of thing is almost always the interconnects but I must admit that would normally isolate the problem to just one channel (unlikely both interconnects have a problem). Another strong possibility is the pre amp and the main amp need to be isolated from each other. If you have one on top of the other currently, I would suggest separating them a bit and see if it affects the noise you are getting.

Ian Colquhoun
President & Chief Engineer