Hi folks.
Because I had to move my gear, I changed my setup a bit to 'simplify' the cabling and have now lost audio when using digital signal from DVDs. Funny part is, stereo still goes through fine.
Basically I introduced switching all my video, including my sat. dish, through the Denon via a HDMI out where as before, it only switched DVD and XBox through component and the sat. dish went separately to the TV via its own HDMI.
Now when using the DVD, I get stereo sound but not digital 5.1 or DTS. I assumed it must be trying to send the digital sound out the HDMI to the TV but the Denon does not even show an input signal coming in to be passed anywhere...
Old setup.
Bell Expressvu to TV via HDMI to DVI cable.
DVD audio to Denon via optical 1.
DVD video to Denon via Component1 to TV via component out 1
XBOX audio to Denon via RCA1
XBOX video to Denon via Component2 to TV via component out 1
New Setup
BBEV audio to Denon via optical 2
BEV video to Denon Via HDMI-In 1 to TV Via HDMI out 1
DVD audio to Denon via optical 1.
DVD video to Denon via Component1 to TV Via HDMI out 1
XBOX audio to Denon via RCA1
XBOX video to Denon via Component2 to TV Via HDMI out 1
DVD Audio setup did not change at all and I know the cable and inputs are OK because it will pass stereo sound when chosen.
As soon as the DVD switches to 5.1 or DTS, the receiver shows no input signal and you get no sound.
I have tried multiple DVD with the same results. I can play a CD (stereo) OK. I have tried switching inputs, went through all menu settings for something missing and I even went as far as reading the manual!
Obviously it has something to do with the introduction of switching HDMI in the receiver and I can revert back to my old ways if need be but I'll have to go out and buy a 5 meter component cable to replicate what I had before over the longer distance.
If anyone can help me to avoid going back, it would be greatly appreciated, if its even possible.
Thanks greatly,
