I have them wired in parallel at the reciever end. So I have the bottom speaker bare in in the binding posts and screwed in, and I have the top speaker plugged in with banana plugs to the same binding post. However, if you had a 7 channel separate amp, and a pre/pro, and you only have a 5.1 system, you could split the centre channel into 2 of the channels on the separate amp, and it would avoid getting a parallel load because each speaker would be on its own channel.
Parallel wiring with the M2s create a 4ohm load but also increases the db output by 3dbs.
The m2s look ALOT better than these M3s I originally had. I will take some new pics and hopefully get them up on the net in the next couple weeks.
