Originally Posted By: jakeman
Presumabley he meant bridged output at clipping as as in excess of 300W at 4 ohms not 8 ohms.

I'm not sure if this makes a difference regarding the 4 ohms vs 8 ohms thing, but the 875 manual on page 24 states in bold:

• Use only front speakers with an impedance of 8
ohms or higher for bridging. Failure to do so may
seriously damage the AV receiver.

It also states the following (which is why I made my original post):

• When using bridging, make sure that your front speak-
ers can handle the additional power.

Since that S&V test says "over 300W" in bridged mode, then it sounds like it would NOT be safe to run the m50's with the 875 bridged... correct?