Axiom Home Page Forums General Discussion Home Theater Center Speaker Stand Ideas???

I have a FMB from Axiom, but to be honest, it was a pain to install and remove the last time I mounted my VP150 (because it was so close to the ceiling). Now that I am enjoying V3.0 (as I call it) of my home theater, the center speaker is below the screen. So I want to get some sort of stand or something to just get the speaker off of the floor.

My oldest daughter was on "vacuum patrol" a few weeks back, and bumped right into the VP150, breaking the "Axiom" tag right off of the front. Then this past weekend, my parents were in town, and my mom (who has VERY bad eye sight) just about stepped on the VP150. I told her to be careful, and she didn't quite get it until I told her that it was a $400 speaker.

So, long story short, I would like to get the center channel off of the ground. I don't know if it would help a lot with my mom, but at least against any accidental bumping into since it would be a little more noticable being off of the ground.

Here is my other limit. The bottom of my screen is only 18 inches off of the ground, leaving less than 11 inches for the stand itself.

Ideas?

Bridgeman likes to use boxes...I think they give a good acoustical tone to the speaker...

In all seriousness, you can easily just build one. Take some MDF for the bottom, take a 4x4 for the pole, take some more MDF for the top, screw them all together...very easy!

Make sure the base is wider than the top.

Perhaps you could talk Axiom into cutting down their new FM-CC center stand to your specs.

I think I’d make it with two posts about twelve inches apart. Make the bottom plate about six inches wider than the speaker and about four inches deeper than the speaker. That will be about right for keeping it stable. Then make the top plate the same dimension as the speaker, or a little smaller if you don’t want it to be viewable. Stick the speaker to the stand with Velcro. I’d use some sort of hardwood and stain it to match whatever colors in your room. I’d make the posts 2 1/4” X 2 1/4” (three laminated 3/4" hardwood boards)and center them between the plates. A little glue and a couple screws should be plenty strong enough. Or, if you have a biscuit cutter, biscuits work very well and don’t take long at all. If you need the speaker to be angle up some, just cut the posts at whatever angle you think you need.

Listen to mdrew, he is a Prestige Magician with wood!

>>I thought it was soup cans? Or is that just for the QS8's?

Bingo. Soup cans for QS8s at the old house (now replaced with the soup-can-inspired but highly attractive FMB-QS stands) and an empty M2i box for the VP100 in the new house.

After seeing Mdrew's beautiful stands I'm not sure what to replace the M2 box with that could possibly measure up... I'm thinking maybe a maglev arrangement...

I could build something, but my problem is that I have such a long list of "not quite finished" projects, that I hate to add another project to the list...

I know they have the FM Custom stand... I also thought I saw a while ago they were releasing a center channel stand?

Perhaps that'd work for you?

- D