Previous Thread
Next Thread
Print Thread
Rate Thread
Page 2 of 5 1 2 3 4 5
Re: Axiom speakers & your AVR crossover setting
Joe_in_SC #305026 05/06/10 12:28 AM
Joined: Sep 2004
Posts: 11,458
shareholder in the making
Offline
shareholder in the making
Joined: Sep 2004
Posts: 11,458
Joe, it's not really new...and to each their own... but the general thinking is to set even speakers that are physically large to the "small" setting, as the sub is still the best speaker to handle the bass. Plus, the subs' amp takes a good load off the receiver, which now doesn't have to push watts for those lower frequencies.

Personally, I have my Denon receiver to send bass to both the M60s and the sub, because in my poor acoustic environment, the more bass sources, the more even the bass response.


::::::: No disrespect to Axiom, but my favorite woofer is my yellow lab :::::::
Re: Axiom speakers & your AVR crossover setting
Joe_in_SC #305027 05/06/10 12:32 AM
Joined: Dec 2008
Posts: 6,928
axiomite
Offline
axiomite
Joined: Dec 2008
Posts: 6,928
Fronts Large 40hz

Centre Small 60hz

Surrounds Small 150hz


Half of communication is listening. You can't listen with your mouth.
Re: Axiom speakers & your AVR crossover setting
Adrian #305028 05/06/10 12:42 AM
Joined: Jun 2003
Posts: 6,833
W
Wid Offline
axiomite
Offline
axiomite
W
Joined: Jun 2003
Posts: 6,833

Just set my center and surrounds to 100HZ. Sounds pretty good, I might up the qs4s and see how they sound.


Rick


"A fear of weapons is a sign of retarded sexual and emotional maturity." Sigmund Freud

Re: Axiom speakers & your AVR crossover setting
Joe_in_SC #305040 05/06/10 02:06 AM
Joined: May 2002
Posts: 10,654
shareholder in the making
Offline
shareholder in the making
Joined: May 2002
Posts: 10,654
Joe, it isn't "new" at all; the basic rationale behind bass management is to have the sub handle the frequencies where it does best, up to 80Hz or so, and to have all the speakers set "Small"(regardless of their physical size)so that part of the bass load is taken off of them and the higher range is played a bit more cleanly.


-----------------------------------

Enjoy the music, not the equipment.


Re: Axiom speakers & your AVR crossover setting
Adrian #305046 05/06/10 02:31 AM
H
htnut
Unregistered
htnut
Unregistered
H
 Originally Posted By: Adrian
Fronts Large 40hz



Doesn't the large setting mean full range, thus effectively eliminating any crossover?

Re: Axiom speakers & your AVR crossover setting
#305048 05/06/10 02:36 AM
Joined: May 2003
Posts: 18,044
shareholder in the making
Offline
shareholder in the making
Joined: May 2003
Posts: 18,044
Well, as I understand it, they will run full range, but the front channel frequencies below 40 hz will also go to the sub.


I am the Doctor, and THIS... is my SPOON!
Re: Axiom speakers & your AVR crossover setting
#305053 05/06/10 02:44 AM
Joined: Dec 2008
Posts: 6,928
axiomite
Offline
axiomite
Joined: Dec 2008
Posts: 6,928
I reran Audyssey and this is what it came up with the last time I ran it. Before that, I was running fronts on small at 60hz, centre small at 80hz and surrounds at 150hz more a less sticking to conventional wisdom. Fred made a good point, imo, about running the fronts large to help even out the bass in the room. I know there's different opinions on this, but the M80's can certainly handle their share of bass, so why not run them large? If you push your reciever to extreme levels, I can understand peoples reluctance to tax the avr amp too much and let the sub amp take over more of the bass, but that's where a separate may be of benefit.


Half of communication is listening. You can't listen with your mouth.
Re: Axiom speakers & your AVR crossover setting
Ken.C #305056 05/06/10 02:45 AM
Joined: Jan 2004
Posts: 13,849
Likes: 15
shareholder in the making
Offline
shareholder in the making
Joined: Jan 2004
Posts: 13,849
Likes: 15
For me all speakers set to small, also confirmed after running Denon setup. Audyssey settings matched what I normally manually followed, 80's at 60hz, 150 at 80hz, Qs8's at 90hz.


M80s VP180 4xM22ow 4xM3ic EP600 2xEP350
AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85


Re: Axiom speakers & your AVR crossover setting
SirQuack #305057 05/06/10 02:48 AM
Joined: Dec 2008
Posts: 6,928
axiomite
Offline
axiomite
Joined: Dec 2008
Posts: 6,928
There must be something a little odd with my room, although it's not much different than what other people have described reg their rooms. I always get, what I consider, high crossover points on the surrounds...up around 120-150hz.


Half of communication is listening. You can't listen with your mouth.
Re: Axiom speakers & your AVR crossover setting
Ken.C #305067 05/06/10 03:21 AM
H
htnut
Unregistered
htnut
Unregistered
H
 Originally Posted By: kcarlile
Well, as I understand it, they will run full range, but the front channel frequencies below 40 hz will also go to the sub.


Thanks, I may try that and see if I like it.

Page 2 of 5 1 2 3 4 5

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,984
Posts442,691
Members15,643
Most Online2,699
Aug 8th, 2024
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,849
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 595 guests, and 0 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4