Previous Thread
Next Thread
Print Thread
Rate Thread
Page 84 of 90 1 2 82 83 84 85 86 89 90
Re: VP180
Dundas #315251 07/18/10 01:52 AM
Joined: Feb 2004
Posts: 1,863
connoisseur
Offline
connoisseur
Joined: Feb 2004
Posts: 1,863
i have m60's and going from the vp-150->180, my levels didnt change much. i used 70db as a base line.

Re: VP180
HTGEEK #315252 07/18/10 02:00 AM
Joined: Feb 2009
Posts: 3,466
connoisseur
Offline
connoisseur
Joined: Feb 2009
Posts: 3,466
You should leave the speaker trims where the receiver sets them. That's the receiver's way of making sure each channel plays at the same level when fed the same signal. The basis is also on the -0 dB setting on the master volume control. The -4.5 dB means that the receiver needs to trim four and a half dB from the output of that channel when the main volume is set to -0 dB to get that speaker to play at "reference" level.

If you had to turn all the trims up 10 dB to get it to sound like you wanted, you should have just turned the master volume control up 10 dB. That does the same thing (on any modern receiver).


Pioneer PDP-5020FD, Marantz SR6011
Axiom M5HP, VP160HP, QS8
Sony PS4, surround backs
-Chris
Re: VP180
ClubNeon #315255 07/18/10 02:14 AM
Joined: Apr 2010
Posts: 96
H
old hand
Offline
old hand
H
Joined: Apr 2010
Posts: 96
Based on what other people have posted in my other thread, I might have an issue with my center channel, since it set the crossover at 200hz. I wrote down the settings that the intial Audyssey calibration gave me, so I will put them back to that level and try turning up the receiver.

My speakers are set at small and the front three speakers are still at 40hz.

Re: VP180
HTGEEK #315256 07/18/10 02:24 AM
Joined: Feb 2009
Posts: 3,466
connoisseur
Offline
connoisseur
Joined: Feb 2009
Posts: 3,466
40 Hz sounds right for the front three. "Small", means, "enable crossover", vs. "large" which means, "no crossover."


Pioneer PDP-5020FD, Marantz SR6011
Axiom M5HP, VP160HP, QS8
Sony PS4, surround backs
-Chris
Re: VP180
ClubNeon #315263 07/18/10 02:58 AM
Joined: Apr 2010
Posts: 96
H
old hand
Offline
old hand
H
Joined: Apr 2010
Posts: 96
Thanks for the information. I have learned quite a bit tonight about all the different settings and what they do. Unfortunately I just made a discovery, with the help of a fellow forum member, that one of my new M80's has two blown woofers... They are only a year old, but I bought them used so I don't have a warranty on them. Not the way I wanted to spend this evening..:(

Re: VP180
HTGEEK #315270 07/18/10 04:26 AM
Joined: Dec 2006
Posts: 3,569
connoisseur
Offline
connoisseur
Joined: Dec 2006
Posts: 3,569
Like has been mentioned in your other thread it’s likely wires or the crossover. Usually tweeters are the first thing to blow on a speaker not to say it couldn’t happen to the woofers but given the power handling capability of Axiom’s midrange and woofer drivers I doubt it.


3M80 2M22 6QS8 2M2 1EP500 Sony BDP-S590 Panny-7000 Onkyo-3007 Carada-134 Xbox Buttkicker AS-EQ1
Re: VP180
grunt #315456 07/19/10 05:25 PM
Joined: Apr 2010
Posts: 96
H
old hand
Offline
old hand
H
Joined: Apr 2010
Posts: 96
Just a quick update on the situation I have been having with M80's...

I spoke with JC this morning and we tried two more things. It has been determined that my issue is most likely the crossover in one of the speakers. JC had me swtich out the woofers and the woofer from the bad speaker worked in the other one.

He is supposed to get back to me later on today.

I will also say that I watched my first movie last night on the updated system. It was a HD movie with a Dolby Digital soundtrack recorded off of ABC-HD. Surprisingly it sounded pretty darn good. Normally when I watch movies on Directv that are in HD, the sound isn't that good and I have to crank the volume up... So even with two non-working woofers in one of the front speakers, the new center and fronts did a great job. My fiance even noticed the increased sound and bass from the center..:)

Re: VP180
HTGEEK #316051 07/22/10 11:33 AM
Joined: Feb 2008
Posts: 1,005
O
onn Offline
connoisseur
Offline
connoisseur
O
Joined: Feb 2008
Posts: 1,005
Picked up my VP180 from Puralator last night. shocked
I did not receive any e-mail saying it was being sent so it was a bit of a shock. I ran into a few problems last night with changing my set up and hope to have everything all sorted out tonight. I will post a couple of pics when I get the chance.
Mel

Re: VP180
onn #316053 07/22/10 12:07 PM
Joined: Mar 2009
Posts: 129
veteran
Offline
veteran
Joined: Mar 2009
Posts: 129
Originally Posted By: onn
Picked up my VP180 from Puralator last night. shocked
I did not receive any e-mail saying it was being sent so it was a bit of a shock. I ran into a few problems last night with changing my set up and hope to have everything all sorted out tonight. I will post a couple of pics when I get the chance.
Mel


You sure have one hell of a system there , you will definitely love the 180.


XPA-3
VP-180v3
M80v3
Svs PC-12 Plus
SVS SSS-2
PS-3
Sharp 60" LED
OPPO BDP-93
Anthem MRX500
Re: VP180
PTPlayers #316120 07/22/10 10:32 PM
Joined: Jun 2003
Posts: 8,488
T
axiomite
Offline
axiomite
T
Joined: Jun 2003
Posts: 8,488
JC recently clarified for me that users SHOULD NOT hang the VP180 using the mounting holes designed for the feet.

FWIW.


bibere usque ad hilaritatem
Page 84 of 90 1 2 82 83 84 85 86 89 90

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,939
Posts442,452
Members15,615
Most Online2,082
Jan 22nd, 2020
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,840
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 221 guests, and 0 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4