You are not logged in. [Log In]


Forums » General Discussion » Home Theater » Subwoofer cables

Page 2 of 2 < 1 2
Topic Options
Rate This Topic
#402699 - 04/08/14 04:40 PM Re: Subwoofer cables [Re: Gr8_White_North]
dberthe Offline
hobbyist

Registered: 04/01/14
Posts: 24
Loc: Southern California
Below is the email reply I received from Andrew Welker:

/* Hi Dave,

The v4 subwoofers do not have any type of auto signal
sensing. The trigger connection will allow you to put the
sub into standby mode when not in use. The trigger
connection is a standard 1/8" / 3.5mm phone jack which is
the same size and type found on many headphones. Your
processor or receiver then needs to have a trigger control
output delivering anything from 9-12V, which is fairly
typical. If you need any assistance in making this
connection, please feel free to shoot me an e-mail.

Thank you,

Andrew Welker
R&D Manager
Axiom Audio */

I hope this info is helpful to some other forum members as well. Thanks, Dave
_________________________
M60v3, VP100v3, QS8v3, EP350v4, Onkyo TX-NR905

M22v2, Vector Research VRX-9000 stereo

AxiomAir

Top
#403059 - 04/14/14 06:19 AM Re: Subwoofer cables [Re: dberthe]
MichaelTrottar Offline
old hand

Registered: 12/10/13
Posts: 84
Shielding becomes important if you have a long-term cable broadcast antenna nearby, or current carrying conductors parallel to the part of your cable run.
_________________________
Cinéma maison Montréal

Top
Page 2 of 2 < 1 2

Moderator:  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 
Forum Stats

15,206 Registered Members
15 Forums
23,962 Topics
423,591 Posts

Most users ever online:
883 @ 03/04/17 05:06 PM

Top Posters
Ken.C 18044
pmbuko 16437
SirQuack 13565
CV 11675
MarkSJohnson 11437
0 registered ()
216 Guests and
5 Spiders online.
Key: Admin, Global Mod, Mod
Newsletter Signup